Remote
Control
Operations
1 | POWER | 4 FAN SPEED SELECTOR |
| Operation starts when this button is pressed and | For increased power while cooling, select a higher |
| stops when you press the button again. | fan speed. |
2 | TEMPERATURE CONTROL | 3 steps: High ➔ Low ➔ Med |
|
ENGLISH
The thermostat monitors room temperature to maintain the desired temperature.
The thermostat can be set between 60°F~86°F (16°C~30°C).
The unit takes an average of 30 minutes to adjust the room temperature by 1°F.
3OPERATION MODE SELECTOR Select cooling mode to cool the room. Select energy saver mode for energy saving operation.
Select fan mode for basic ventilating fan operation. Select dry mode for dry operation.
AUTO RESTART
5ON/OFF TIMER
The timer can be set to start and stop the unit in hourly increments (up to 12 hours).
6REMOTE CONTROL SENSOR
In failure of electric power, the unit runs as previous setting operation.
Inserting
the
Remote
Control
Batteries
1Push out the cover on the back of the remote control with your thumb
2 Pay attention to polarity and insert two new AAA 1.5V batteries.
3 Reattach the cover.
NOTICE : Do not use rechargeable batteries. Make sure that both batteries are new.
• In order to prevent discharge, remove the batteries from the remote control if the air conditioner is not going to be used for an extended period of time
Keep the remote control away from extremely hot or humid places.
To maintain optimal operation of the remote control, the remote sensor should not be exposed to direct sunlight.
• The remote control can be mounted on a wall using the mountable holder.
9