AC Connection

Remove the Battery Compartment by pressing in on the tab and then sliding the compartment out.

Install a CR2025 battery, paying attention to the polarity diagram in the Battery Compartment (positive side up). Replace the Battery Compartment.

Insert the small end of the AC adapter into the POWER IN jack (located on the rear of the unit). Connect the AC cord to the adapter and connect the other end to a wall outlet having 120V AC, 60 Hz. AC Adapter, DC 20V Z

AC Outlet

AC Plug

NOTES:

• The AC adapter supplied with the unit is polarized to help minimize the possibility of electric shock. If the AC plug does not ﬁt into a nonpolarized AC outlet, do not ﬁle or cut the wide blade. It is the user’s responsibility to have an electrician replace the obsolete outlet.

• Remove both the DC plug and the AC-IN plug to disconnect the AC adapter when not in use.

• Only use the supplied AC Adapter which has the following specs: DC 20V Z

REMOTE BATTERY INSTALLATION 1.

BATTERY PRECAUTIONS

Follow these precautions when using a battery in this device:

1. Use only the size and type of battery speciﬁed.

2. Be sure to follow the correct polarity when installing the battery as indicated in the Battery Compartment. A reversed battery may cause damage to the device.

3. If the device is not to be used for a long period of time, remove the battery to prevent damage or injury from possible battery leakage.

4. Do not try to recharge a battery not intended to be recharged; it can overheat and rupture. (Follow battery manufacturer’s directions.)