Insertion and Removal of Cassette, Playback

INSERTION AND REMOVAL OF CASSETTE

–Press Stop / Eject Key to open the cassette door.

–Put your cassette tape down the holder properly, with the exposed section Downward and the playback side facing you.

–Close the cassette door securely before starting.

–When finished press Stop / Eject Key to open the cassette door and retrieve your cassette tape.

–You can choose either TAPE A / 1 or TAPE B / 2 for playback.

–Press the TAPE Button.

–Put in your cassette tape.

–Press Play Key to activate playback.

–Adjust the Volume Controls to the desired level.

–Use Pause Key whenever you want to stop playback temporarily.

–Press Stop / Eject Key when finished.

–Press the TAPE Button.

–Put in your Cassette Tapes.

–Press Play Key of Deck A / 1.

–Press Pause Key and Play Key of Deck B / 2.

–Deck A / 1 will activate while Deck B / 2 is at Rest.

–Adjust Volume Control to the desired level.

–When Tape A / 1 reaches its end and stops. Tape B / 2 starts playing automatically.

–When Tape B / 2 runs to its end. It will automatically stop.

– Press the Tuner button.

– Tune in your station and put in your cassette tape.

– Press Record Key and the Play Key of deck at the same time to start recording.

– Press STOP / EJECT Key when finished.

Note: If beat noise is present when recording. Adjust the position of the Beat Cut Switch on rear panel for AM only.

–Press the CD Button.

–Insert a cassette suitable for recording, press pause key then press record key. Recording function will be on stand by.

–Activate the CD player, and then press (to release) Pause Key to start recording.

–To stop recording, first press STOP Button on CD player – then press the STOP / EJECT Key on tape deck.

–Insert a pre-recorded cassette with full reel on the left into Deck A / 1.

–Insert a blank cassette Tape with full reel on the left into Deck B / 2.

–Press the Tape Function Selector, set the dubbing mode selector to “NORMAL” position.

–Press Play key of Tape A / 1 and Record Key together with the Play Key of Tape B / 2 at the some time then both Tapes start dubbing synchronously.

–Adjust the Volume Controls to the desired output level and also for the monitoring purpose.

–To Stop Dubbing, press both Stop / Eject Keys.

–Following the steps of normal speed dubbing procedure, but set the dubbing mode selector to “HIGH SPEED DUBBING” position.

E-10

11/8/01, 11:11 AM