Makita EW200TR, EW300TR, EW400TR instruction manual Preparationsfor Storage

Page 17

10.PREPARATIONSFOR STORAGE

~~~~

IDrain all water from the drain plug.

[CAUTION

IWhen retightening drain plug, be

 

,

1u

 

 

sure to clean the drain plug and the

 

 

 

thread of casincl. Otherwise, the

JI

1I

 

thread may be da6aged.

 

Remove the strainer cup, and open the strainer cock to discharge the fuel from the fuel tank.

Remove the carburetor float chamber bolt from the bottom and discharge fuel from the carburetor. (NO SMOKING !)

Change the used engine oil with fresh oil.

Remove the spark plug, pour about 5 cc of engine oil into the cylinder, slowly pull the starter knob of the recoil starter 2 or 3 times, and tighten the spark

Plug.

Slowly pull the recoil starter knob until resistance is felt and leave it in that position.

Store the pump in a dry place free from sand or dust.

Always keep the pump covered.

- 14 -

Image 17
Contents 2 O O T R Model E W 3 O O T R EW400TR Page Foreword ContentsSurroundings Exhaust PrecautionFire Prevention Other Important PointsPage Connect the suction hose Preparations for StartingCheck the fuel level EW400TR Starting the EnginePage Operation Stopping Enginewith the Fuel Cock Stopping the EnginePeriodic Inspection Daily InspectionEngine OIL Change Cleaning Fuel StrainerInspecting the Spark Plug Fuel Pipe Replacement Servicing the AIR Cleaner Cleaning Pump Inside Checking BOLTS, Nuts and ScrewsCEngine speed is too low Consult your nearest dealer Starting Preparationsfor Storage OIL Sensor Option OIL Sensor InstructionsPage Makita Corporation