Harbor Freight Tools Model 93819 specification

GROUNDED TOOLS: TOOLS WITH THREE PRONG PLUGS

1.Tools marked with “Grounding Required” have a three wire cord and three prong grounding plug. The plug must be connected to a properly grounded outlet. If the tool should electrically malfunction or break down, grounding provides a low resistance path to carry electricity away from the user, reducing the risk of elec- tric shock. (See Figure B.)

2.The grounding prong in the plug is connected through the green wire inside the cord to the grounding system in the tool. The green wire in the cord must be the only wire connected to the tool’s grounding system and must never be attached to an electrically “live” terminal. (See Figure B.)

3.Your tool must be plugged into an appropriate outlet, properly installed and grounded in accordance with all codes and ordinances. The plug and outlet should look like those in the following illustration. (See Figure B.)

THIS PRODUCT

USES A

3-PRONG

ELECTRICAL

PLUG

120 VOLT,

GROUNDED,

ELECTRICAL OUTLET

FIGURE B

DOUBLE INSULATED TOOLS: TOOLS WITH TWO PRONG PLUGS

4.Tools marked “Double Insulated” do not require grounding. They have a special double insulation system which satisfies OSHA requirements and complies with the applicable standards of Underwriters Laboratories, Inc., the Canadian Standard Association, and the National Electrical Code. (See Figure C.)

5.Double insulated tools may be used in either of the 120 volt outlets shown in the following illustration. (See Figure C.)

THIS PRODUCT

DOES NOT USE A

2-PRONG