State Industries SUF 130 THRU 500 manual General Information, GAS Pressure Specifications

Page 6

GENERAL INFORMATION

INSTALLATION REQUIREMENTS FOR THE COMMONWEALTH OF MASSACHUSETTS

For all side wall terminated, horizontally vented power vent, direct vent, and power direct vent gas fueled water heaters installed in every dwelling, building or structure used in whole or in part for residential purposes, including those owned or operated by the Commonwealth and where the side wall exhaust vent termination is less than seven (7) feet above finished grade in the area of the venting, including but not limited to decks and porches, the following requirements shall be satisfied:

INSTALLATION OF CARBON MONOXIDE DETECTORS

At the time of installation of the side wall horizontal vented gas fueled equipment, the installing plumber or gas fitter shall observe that a hard wired carbon monoxide detector with an alarm and battery back­up is installed on the floor level where the gas equipment is to be installed. In addition, the installing plumber or gas fitter shall observe that a battery operated or hard wired carbon monoxide detector with an alarm is installed on each additional level of the dwelling, building or structure served by the sidewall horizontal vented gas fueled equipment. It shall be the responsibility of the property owner to secure the services of qualified licensed professionals for the installation of hard wired carbon monoxide detectors. In the event that the side wall horizontally vented gas fueled equipment is installed in a crawl space or an attic, the hard wired carbon monoxide detector with alarm and battery back-up may be installed on the next adjacent floor level. In the event that the requirements of this subdivision can not be met at the time of completion of installation, the owner shall have a period of thirty (30) days to comply with the above requirements provided that during said thirty (30) day period, a battery operated carbon monoxide detector with an alarm shall be installed.

APPROVED CARBON MONOXIDE DETECTORS

Each carbon monoxide detector as required in accordance with the above provisions shall comply with NFPA 720 and be ANSI/UL 2034 listed and CSA certified.

SIGNAGE

A metal or plastic identification plate shall be permanently mounted to the exterior of the building at a minimum height of eight (8) feet above grade directly in line with the exhaust vent terminal for the horizontally vented gas fueled heating appliance or equipment. The sign shall read, in print size no less than one-half (1/2") inch in size,

“GAS VENT DIRECTLY BELOW. KEEP CLEAR OF ALL OBSTRUCTIONS.”

GAS PRESSURE SPECIFICATIONS

MODELS

Natural

Propane

Natural

Propane

Natural

Propane

120‑150

120‑150

199‑250

199‑250

300/400/500

300/400/500

 

Maximum Gas

10.5" WC

14.0" WC

10.5" WC

14.0" WC

11.0" WC

14.00" WC

Supply Pressure

(2.59 kPa)

(3.45 kPa)

(2.59 kPa)

(3.45 kPa)

(2.74 kPa)

(3.49 kPa)

Nominal Gas

7.0" WC

11.0" WC

7.0" WC

11.0" WC

7.0" WC

11.0" WC

Supply Pressure

(1.74 kPa)

(2.74 kPa)

(1.74 kPa)

(2.74 kPa)

(1.74 kPa)

(2.74 kPa)

Minimum Gas

 

 

 

 

 

 

Supply Pressure

4.8" WC

11.0" WC

4.8" WC

8.5" WC

5.2" WC

11.0" WC

(Low Gas Press.

(1.20 kPa)

(2.74 kPa)

(1.20 kPa)

(2.12 kPa)

(1.54 kPa)

(2.74 kPa)

Switch Setting)

 

 

 

 

 

 

Manifold Pressure

4.0" WC

10.0" WC

0" WC

0" WC

4.00" WC

10.0" WC

(0.98 kPa)

(2.49 kPa)

(0 kPa)

(0 kPa)

(1.25 kPa)

(2.49 kPa)

 

4

Servicing should only be performed by a Qualified Service Agent

Image 6
Contents Commercial GAS High Efficiency Water Heaters Page Table of Contents Introduction QualificationsTools Required GAS Pressure Specifications General InformationInstallation Quick Tips SUF 120 and 150 GAS Pressure Adjustment Procedure GAS Pressure SUF 120 and 150 ModelsPage Installation Quick Tips SUF 199 and 250 GAS Pressure Important NoteInstallation Quick Tips SUF 300, 400, 500 GAS Pressure Adjustment Procedure GAS Pressure SUF 300, 400Installation Quick Tips SUF 300, 400 Installation Venting Category and Materials Ultra Force VentingVenting Tables SUF 120 Vent Length Table Equivalent Feet Meters 120 throughVent Length Table Equivalent Feet Meters 300, 400 Concentric Venting What about the PH Values of Condensate and Soda POP? Vent CondensationCan I Drain this Condensation to the Floor DRAIN? What does the PH Scale MEAN?Power Vent Direct Vent Vent Termination Direct Vent ALL Models Direct Venting ALL Models PVC ElbowControl Overview Status Icon Description Set PointDisplay Action Adjusting Tank Temperature Operating SET Point DifferentialAction DisplayPress Update to accept the change or Cancel to reset it Changing the Display Units Press Update to accept the change or Cancel to reject it Example of a Fault Advanced Diagnostic Information Example of a WarningAccess to the Current Fault or Warning To get to the current fault information screen, press MenuPress the Down button for more information Fault Codes Viewing Information About the Water Heater Control Sequence Typical ALL Models Typical SequenceControl Sequence Flow Chart Controls Central Control Board CCB This is the back of the UIM Controls GAS Valve SUF High Altitude Installation Controls GAS Valve SUF 199GAS Orifice Controls GAS Valve SUF 199 Controls GAS VALVE, Orifice Chart SUF 300/400 Orifice Chart SUF 300Controls GAS VALVE, Orifice Chart SUF Orifice Chart SUFBlocked Outlet Proving Switch Controls Pressure Switches ALL ModelsBlower Proving Switch Blocked Inlet Proving SwitchControls Pressure Switches SUF 120 Through Controls Pressure Switches SUF 300, 400 Page Flame Sensor HOT Surface Igniter / Flame Sensor / Control TimingHOT Surface Igniter Control TimingBlower Speed Control SUF 199 Model High Speed Hz Low Speed HzVariable Frequency Drive SUF 400 Variable Frequency Drive Blower Speed and Pressure Readings Voltage Frequency Speed Instructions VFD Model SUFWiring Diagram SUF 120 User Interface ModulWiring Diagram SUF 400 User Interface ModuleTennessee Waltz Parkway Ashland City, TN

SUF 100 THRU 250, SUF 130 THRU 500, SUF 60 THRU 120 specifications

State Industries has long been a leader in the manufacturing of high-quality water heaters, particularly known for its SUF series. The SUF 60 thru 120, SUF 130 thru 500, and SUF 100 thru 250 models are excellent examples of State Industries’ commitment to efficiency, performance, and innovation. These units are designed to meet a range of residential and commercial water heating needs, showcasing advanced engineering and durability.

The SUF series is primarily built for heavy-duty applications, offering various capacities to accommodate different demands. The SUF 60 thru 120 models are ideal for residential settings, providing dependable hot water solutions with capacity options ranging from 60 to 120 gallons. These units utilize high-quality insulation to minimize heat loss, resulting in improved efficiency and cost-effectiveness.

Moving to the SUF 130 thru 500 series, these models are tailored for larger commercial applications. With capacities extending up to 500 gallons, they are perfect for industries where high volume and consistent hot water supply are essential. The SUF 130 thru 500 models feature robust heating elements and advanced thermostats for precise temperature control, ensuring the delivery of hot water on demand.

The SUF 100 thru 250 units straddle the line between residential and light commercial applications. With capacities from 100 to 250 gallons, these water heaters are versatile and adaptable to various settings. They integrate cutting-edge technology that enhances safety, such as multi-level safety controls and automatic shut-off systems, ensuring user protection while maximizing performance.

Each SUF model is designed with longevity in mind. The tanks are constructed from high-grade materials that resist corrosion and wear, featuring factory-installed anode rods to enhance the lifespan even further. The energy-efficient design of these water heaters meets or exceeds current energy conservation standards, providing an eco-friendly solution without compromising on output.

In summary, State Industries’ SUF 60 thru 120, SUF 130 thru 500, and SUF 100 thru 250 models exemplify the brand’s dedication to quality and innovation. With various capacities, advanced technologies, and a focus on efficiency and durability, these water heaters cater to diverse needs, ensuring reliable hot water supply for years to come.