MX3900.O/M.QXD 4/30/02 11:08 AM Page 7
OPERATING INSTRUCTIONS (CONTINUED)
LISTENING TO THE RADIO
1 |
2 |
3 |
Press the POWER button to turn the unit on.
Press the TUNER/Band button; “TUNER” will appear in the display.
Press the TUNER/Band button to select AM or FM.
NOTE: If you select the FM band, be sure to extend the FM Wire Antenna.
4 | 1 |
2 |
5 | 2 |
| 1 |
6 |
Press the TUNING/CD Skip/Search 
❶ or 
❷ button to select a station (see Tuning note below).
NOTE: If the FM band is selected and you have tuned to an FM Stereo station, the FM Stereo indicator will light in the display.
Adjust the
When you have finished listening, press the POWER button to turn the unit off.
TUNING:
MANUAL TUNING: Repeatedly press the TUNING/CD Skip/Search 
or 
to manually advance the frequency in the display up or down until the desired frequency appears.
AUTOMATIC TUNING: Press and hold the TUNING/CD Skip/Search 
or 
until the frequency in the display starts to scan, and then release the button; the tuner will search and then stop on the next strong station it finds. Repeat this procedure until the desired frequency appears in the display.
Hints for Better Reception
FM - Make sure that the FM Wire Antenna is extended to its full length. You may have to vary the direction of the antenna to find the strongest signal for each FM station.
AM - The AM ferrite bar antenna is located inside the unit. It may be necessary to turn the unit slightly so that the internal antenna is pointing in the direction of the AM transmitter. You may have to experiment to find the position that provides the strongest reception for each of your favorite AM stations.
MUTE |
1 |
To temporarily mute the sound, press the MUTE button on the remote control; the Mute indicator will appear in the display and the sound will be muted. Press the MUTE button again to restore the sound and the Mute indicator will disappear from the display.
7