Top Innovations SP-402 owner manual Threading the Machine

IMPORTANT!

"THREADING THE MACHINE"

INSTRUCTION MANUAL SUPPLEMENT

The purpose of this insert is to supplement the information given in the "Threading the Machine" section on pages 10 & 11 of the instruction manual. Specifically, it is meant to clarify steps 3 & 4 by illustrating the necessary procedures in further detail. Follow the steps below, in combination with the information given in the instruction manual, to properly thread the machine.

NOTE: Refer to the illustrations on the other side of this sheet for assistance in completing the following steps.

1)Feed the thread around the Guide Bar located at the 3 o'clock position on the Disc Thread Guide (FIGURE 1).

2)Insert the Needle Threader down through the Guide Bar that is located at the 9 o'clock position on the Disc Thread Guide (FIGURE 2).

3)Feed the slack end of the thread through the Needle Threader (FIGURE 3).

4)Pull Needle Threader (with thread inserted) back up through the Guide Bar (FIGURE 4).

9 o'clock Position

Guide

Bar

Disc Thread Guide

LONG

SHORT STITCH

STITCH

QUIKSTITCH

3 o'clock

Position Guide Bar

Needle

Threader

3 o'clock	9 o'clock
Guide	Guide
Bar	Bar

FIGURE 1 FIGURE 2

FIGURE 3 FIGURE 4