loosen
N
Adjusting | Lower | Tension |
To test bobbin tension, hang and shake bobbin case as shown.
At proper tension bobbin case will gradually drop a small amount.
To adjust tension, turn adjusting screw with small screwdriver.
Raise needle in the highest position.
Leave end of thread of about 1 0 cm (4”) from bobbin case.
Take hold of latch and push bobbin case into shuttle Release latch when bobbin case is fully inserted.
DROP FEED LEVER
The leier is in the right side of shuttle cover. For normal sewing, move the lever to A4 position.
To lower feed dog, move the lever to AEA position.
This position is used for button sewing, darning and embroidery.
1 | 2- |