INSTALLING MACHINE HEAD IN PORTABLE
AND CABINET
Loosen the two hinge screws under holes in the rear edge of the machine bed (1) Raise hinge pins in the cabinet cutout (2), Slip machine head onto the pins and tighten hinge screws securely (3),.
Lower machine head to front flap+
Screw spoor pins in place+ Lay the plastic discs over
the spool pins D_scs and pins are packed in the accessory box
| SEWING | LIGHT |
|
|
|
|
|
|
|
| ||||
| The sewing tight is located inside the face cover plate | |||||||||||||
| as shown, |
| tt may be turned | on or | off | by | pushing | the | ||||||
| light |
| switch |
| In order | to | operate | the | machine | the | ||||
0 | switch | must | be | on. |
|
|
|
|
|
|
|
| ||
To | remove |
| bulb, turn | light switch |
| off, | open the | face | ||||||
| cover plate by swinging it open, push bulb in slightly, | |||||||||||||
| turn bulb clockwise, and remove from socket+ To | |||||||||||||
| repEace push in new bulb and turn counter clockwise,+ | |||||||||||||
| See | illustration | 4, |
|
|
|
|
|
|
|
| |||
| CONNECTING | MACHINE |
|
|
|
|
|
| ||||||
| Push |
| the | plug | onto | connector | under | the | ||||||
| bed | plate+ | Plug | machine | cord | into | any | wall | ||||||
| outlet° | See | illustration |
| 5 |
|
|
|
|
|
|
,d