Pella 801P0101 Setting and Fastening the Window, % So It Overhangsa TostheExterior

1 ROUGH OPENING PREPARATION (CONTINUED)

E.Apply sill flashing tape #1#UT A PIECE OFImASHING TAPE  LONGERI than the opening width. Apply at the bottom of the opening as shown

% SO IT OVERHANGSA TOSTHEEXTERIOR

Note: The tape is cut 12" longer than the width so that it will extend 6" up each side of the opening.

F.Tab the sill flashing tape and fold#UT  WIDE TABSIAT EACHTCORNER FROM EACHESIDE OF CORNER E& F&OLDLTAPE TOATHEEEXTERIOR AND PRESSSlRMLYlTO ADHEREEIT TOTTHETWATERTRESISTIVEEBARRIER

' Apply sill flashing tape #2#UT A PIECE OFImASHING TAPE  LONGERI THAN THE OPENING WIDTHE!PPLY ATYTHEABOTTOMHOVERLAPPINGPTAPE BYY AT LEAST  $OONOTNALLOWWTHETTAPE TOTEXTEND PASTOTHEEINTERIOR FACE OFE THEHFRAMINGR' 

Note: The flashing tape may not fully cover the framing members.

2 SETTING AND FASTENING THE WINDOW

A.Install and level sill spacers0LACE EWIDE BYY THICK SPACERS ONK THEHBOTTOM OFTTHEOWINDOWWOPENINGE FROM EACHESIDEH3PACERS ARE also required at points where windows are joined in multiple window applications. Add shims as necessary to ensure the spacers are level. Once level, attach spacers and shims to prevent movement.

Note: Improper placement of shims or spacers may result in bowing the bottom of the window.

1"

1E

6"

1/2"

1/2"

1F

1"

1G

2A

B.Remove plastic wrap and cardboard packaging from window. DO NOT remove plastic shipping spacers located between the window sash and frame. The shipping spacers will help keep the window square during installation. DO NOT unlock or open the window until it is fully fastened.

Note: If screens, grilles or hardware are removed from the window at this time, label them and store them in a protected area.

C.Fold out installation fin to 90°. Be careful not to remove or tear

THEHlN CORNERS

Note: If the fin is not at 90°, the window will not line up correctly on the interior.

2C

TWO OR MORE PEOPLE WILL BE REQUIRED
FOR THE FOLLOWING STEPS.	2D

D. Insert the window FROM THE EXTERIOREOF THE BUILDING 0LACE the bottom of the window on the spacers at the bottom of the opening, then tilt the top into position. Center the window between the sides of the opening to allow clearance for SHIMMINGMANDNINSERTTONEOROOlNGlNAIL INNTHEIlRST HOLE FROM THE CORNER ONEEACH END OFETHECTOP NAILING lNF4HESEEAREEUSED TOEHOLDD the window in place while shimming it plumb and square.