Enviro EP3 owner manual Efficiency

Operating Instructions

STOVE CONTROLS - CIRCUIT BOARD:

1.AUGER TRIM: Used to change feed rates on LOW ONLY for poorer quality fuels. Push the Auger Trim button until the number 1 and 5 lights appear on the Heat Level Indicator. This will increase the feed rate to 4 seconds ON time Auger pulse. This is done only on LOW to allow the burning of poor quality fuels. Push the button until the number 1 and 4 lights appear, this will reduce the Auger On time to 2 second. This setting is for high-grade fuel only. Push the button until just the number 1 light is on, this is for a three (3) second on time (standard setting).

2.CONVECTION BLOWER CONTROL: Used to turn the convection blower ON/OFF. If the Blower is left off, and the sensor located on the air jacket reaches 160 °F (71 °C), the Convection blower will automatically come on HI speed to cool the unit. Leave the convection blower ON for peak

	efficiency
	AUGER TRIM
	�
�	�
	FAN
	�
	�
	MANUAL FEED
	�
	ON/OFF
�	�
	HEAT LEVEL

Figure 4: Circuit board control panel.

3.AUGER PULSE LIGHT: This light will flash in conjunction with the auger.

4.MANUAL AUGER FEED: If the unit runs out of fuel, this button can be used to “prime the auger system”. This button will turn off after 60 seconds and then must be released and pressed again.

5.SYSTEM LIGHT: Responsible for signaling the state of the control board. When the light is flashing during start-up, the stove is in an automatic start mode. When the light is solid, the Heat Level Setting can be altered.

6.ON/OFF BUTTON: Used to turn the unit ON and OFF.

7.HEAT OUTPUT INDICATOR: Shows the present heat output setting.

8.HEAT LEVEL ADJUSTMENT: When pressed, will change the heat setting of the unit from low to high.

Auger Trim

2Seconds "ON"

Auger Trim

3 Seconds

"ON"

Factory Setting

Auger Trim

4Seconds "ON"

Figure 5: Auger trim and heat level indicator.

8