Enviro C-10969 owner manual Warranty, To the Distributor, For the do-it-yourself Individual

Page 11

Warranty

Sherwood Industries Ltd. gives a five year limited warranty on all steel manufactured parts. A one-year warranty is provided on all electrical components. The above limited warranties are extended only to the original purchaser.

There is no warranty on the following parts:

Glass window

Fiberglass rope gaskets

refractory material

burn pot liner

paint

enamel finish or gold plating where it applies

**NOTE: The paint on the brick firebox lining may peel. This is due to the extreme conditions applied to the paint and is in no way covered under warranty.

WHEN FILING A WARRANTY CLAIM PLEASE COMPLETE THE FOLLOWING INFORMATION ON AN OFFICIAL WARRANTY CLAIM FORM:

TO THE DEALER:

-Name and address of dealer,

-Date of purchase

-Name, address and telephone number of purchaser

-Name, address and telephone number of installer

-Date of installation, and

-Serial number of the appliance

Ensure that you specify the nature of the complaint, defect, periodical malfunction, etc.

TO THE DISTRIBUTOR:

-Sign and verify that work and information are correct.

-Description and part # of any parts replaced.

The limited warranty covers defects in materials and workmanship as long as the products has been installed according to the manual’s instruction. If the product is damaged or broken as a result of mishandling or misuse, the warranty does not apply. Removal and re-installation costs are not covered under this warranty.

It is the manufacturer’s option whether to repair or replace the appliance. The shipping cost to and from the factory is to be paid by the consumer. All warranties by the manufacturer are set forth herein and no claim shall be made against the manufacturer on any oral warranty or representation.

The manufacturer assumes no responsibility for damage caused by household power fluctuations or power surges.

Under Warranty

For the do-it-yourself Individual

The consumer should be aware that the pellet appliance needs setting using tools that he/she might not have. It is recommended that you have a qualified installer install your pellet appliance

Sherwood Industries Ltd. reserves the right to make changes without any notice.

11

Image 11
Contents Empress Table of Contents Store pellets at least 36 1 m away from the pellet stove IntroductionUSE of Cordwood is Prohibited by LAW Keep ASH PAN Free of RAW Fuel Special Notes Slider / Damper Must be SET AT Time of InstallationOperating Instructions Initial START-UP See above Thermostat / Switch ModeBurn POT and Liner 2-3 days Routine Cleaning and MaintenanceTools Required to Clean Unit Door Glass Cleaning When neededDo not Place Unburned or RAW Pellet Fuel in ASH PAN Replacing Door Glass Post Season CLEAN-UPCleaning Surfaces Firebox PanelFor the do-it-yourself Individual WarrantyTo the Distributor Name of Owner Address Installation Data Sheet