Harman Stove Company TLC 2000 manual Chimney, Wall PASS-THROUGH

TLC 2000 Coal Stove 18

Hole with a minimum clearance of 18" (450 mm) between connector and wall.

Non-combustible cover, one side only. If two covers are used, each must be mounted on non-combustible spacers at least 7/8" (21mm) away from the wall.

Closest	Minimum 2" (50mm)
Combustible
Material	Clearance to Brick

Liner	Minimum 12"
	(300mm) to Brick

	Flue	Fire Clay
		Thimble
	Chimney	Chimney
		Connector
1" (25mm)	Masonry Chimney Built to
Clearance
	NFPA 211 Specifications.
	Minimum 12" (300mm)
AN APPROVED CANADIAN	to Combustibles
	AN APPROVED U.S.
WALL PASS-THROUGH	WALL PASS-THROUGH

The NFPA (National Fire Protection Association) permits four methods for passing through a combustible wall. A commonly used method to pass through a wall directly to a masonry chimney is to clear a minimum 12"(300 mm) around the entire chimney connector, and fill it with brick masonry which is at least 3.5"(90 mm) thick. A fireclay liner, minimum 3/8" (9 mm) wall thickness must run through the brick wall to the chimney liner (but not beyond the inner surface of the liner). It must be cemented in place with refractory cement. This method is illustrated. For details on the other three op- tions, refer to the most recent edition of the NFPA 211 code.

The Chimney

The TLC 2000 must be installed into  a chimney approved for use with solid-fuel appliances. In the U.S., the TLC 2000 must be connected to (1) a prefabricated chimney complying with the requirements for Type HT chimneys in the Standard for Chimneys, Factory-Built, Residential Type and Building

More Than 10 ft. (3m)

10 ft. (3m)

2 ft. (0.6m) min.

Ridge

Chimney

Height Necessary Above Any Roof Sur- face Within 10ft. (3m)

3ft. (0.9m) minimum above exit

point

Heating Appliances, UL 103, or (2) a code-approved masonry chimney with a flue liner. In Canada, the TLC 2000 is listed for use with prefabricated chimneys tested and listed to the high temperature (650 degrees C) chimney standard, ULC S-629, or with a code approved masonry chimney.

The minimum recommended height for any chimney is

16 ft (4.8 m) above flue collar height. A round flue (either masonry or approved prefabricated), of either 6" (150 mm), 7" (180 mm) or 8" (200 mm) may be used. For square or rectangular masonry chimneys, nominal sizes of 8" x 8"or 8"x 12" (200 mm x 200 mm, 200 mm x 300 mm) may be used.

The 3-foot, 2-foot, 10 foot rule

Codes require that solid-fuel chimneys extend 3 ft (0.9 m) above the point at which they exit from the roof, provided that no part of any structure is within the top of the chimney, then the chimney must extend 2 ft (6 m) above the highest point with the 10 ft (3 m) radius top height. If there is not ten feet of clearance from the top of the chimney, then the chimney must extend 2 ft (6m) above the highest point with the 10 ft (3m) radius.