Coleman 9780 manual English-8, Initial Fueling of Dry Pump

Note: For proper lighting, perform Step 6 ONLY for the first time use “out of the box” or when pump is dry (for example, after extended storage). This step is not required during subsequent lighting.

6 Initial Fueling of Dry Pump

■Make sure all FUEL VALVES are fully “OFF” (Fig 16).

OFF

OFF

OFF

FIG. 16

■Turn both flame adjusters to “High/Light” (Fig. 17 and 18).

FIG. 17 FIG. 18

■Place thumb over hole in PUMP KNOB and pump five full strokes (Fig 19).

■Open both fuel valves to the burners (Fig. 20).

■Open fuel valve on bottle 1/2 turn for five seconds, then close fuel valve (Fig. 21)

NOTE: Air in the dry pump is now replaced with liquid fuel. Proceed to Step 7.

ON

ON

FIG. 19 FIG. 20

OPEN

1/2 TURN FOR FIVE SECONDS

FIG. 21

English-8