OPERATING INSTRUCTIONS
READ ALL SAFETY WARNINGS AND INSTRUCTIONS CAREFULLY.
WARNING
•DO NOT allow gasoline or other flammable vapors or liquids to come in contact with stove while lighting or at any time during use of stove.
Step 1
Make sure "Gas Leak Testing" from page 4 was completed and the burner control knob is in the "OFF" position and stove is on a flat surface away from combustible material.
Step 2
Using a match, hold the flame beside burner. Turn the burner control knob SLOWLY
WARNING: If the burner does not light within 5 seconds, turn the burner control knob "OFF" immediately. Wait at least 5 minutes until gas fumes have dissipated before attempting to light burner again.
Step 3
Adjust burner flame as necessary by using burner control knob. Turn stove "OFF" using burner control knob when stove is not in use.
Step 4
Allow stove to cool completely, then follow instructions in the
Minimum clearance to
combustibles 36 inches from top
and side of stove burners
36"
36"
Perimeter of base of stove
Match | Control Knob |
|
ON / Larger Flame
OFF
ON
OFF / Smaller Flame
NOTE: Observe flame height and color when lit. Flame should have a blue center and a slight yellow tip.
Burner 
Yellow
Blue
5