Frigidaire D50D, D70D, D25D operation manual Drain Hose Routings, Dismantle

www.sylvane.com 1-800-934-9194

920-198-10

Drain Hose Routings

When using the function of continuous drainage, the drain hose must be placed horizontally below the drainage hole (See Figure 23).

You must avoid uneven ground and folding the hose (See Figure 23).

Figure 23

FRD026

Continuous Draining using the Pump (D50D/D70D models only) Installation:

STEP 1. Connect the attached continuous drainage adaptor (1) to the drain hole on the rear panel (2).

STEP 2. Connect the supplied water hose to the plug that fits into the drain hole.

STEP 3. Lead the other end to a suitable location for drainage, like a drain or sink and insert the plug into the water drain.

The maximum distance and the rise may be 15 ft from the unit. Exceeding this distance may damage the unit or cause leaks. When the unit’s drain bucket capacity reaches a certain water level, it will drain automatically (See Figure 24).

Dismantle:

Press the drain hole (3) on the unit rear panel. The automatic drainage adaptor will pull out (See Figure 24).

Figure 24

3

1

2

SUPPLIED

WATER

HOSE

PLUG

FRD027

NOTICE

In the automatic mode, the condensed moisture is always removed through the air exhaust hose. Removing the rubber plug from the water drain will allow the water to drain out at this point. The water drain can not be used.

9