Multiquip MTX80SD manual Maintenance, Every 80 to 100 Hours, Long Term Storage

Page 17

maintenance

DAILY

„„Thoroughly remove dirt and oil from the engine and control area.

„„Clean or replace the air cleaner elements as necessary. Check and retighten all fasteners as necessary.

„„Check the spring box and bellows for oil leaks. Repair or replace as needed.

EVERY 50 HOURS

„„Inspect in-line fuel filter (Part Number 26365012A3, Figure 12) and replace if necessary.

Figure 12. In-Line Fuel Filter

„„Remove and clean the spark plug, then adjust the spark gap to 0.024~0.028 inch (0.6~0.7 mm).

EVERY 80 to 100 HOURS

„„Remove the air cleaner cover. Loosen and remove the 2 screws that hold the cover to the air cleaner assembly. If the primary element (Figure 13) is dirty, wash it with gasoline or kerosene. Then dip it in engine oil (SAE10W-30) and wring the element so that 25 to 30 cc of engine oil remains on the element.

of 10W-30 SE, SF or higher grade motor oil. Oil should be midway in sight glass. Break in oil should be changed after first 50 hours.

OIL FILL PLUG

SIGHT GLASS

OIL DRAIN PLUG

Figure 14. Oil Drain Plug

EVERY 6 MONTHS

„„Clean the inside of the fuel tank with solvent.

„„Inspect and clean fuel strainer (Figure 15). Replace strainer if necessary.

FUEL

STRAINER

Figure 15. Fuel Strainer

EVERY 2 YEARS

„„Replace the fuel line every 2 years even if there is no visible damage.

PRIMARY

ELEMENT

Figure 13. Air Cleaner Primary Element

EVERY 200 HOURS

„„Remove the oil drain plug on foot housing (Figure 14) and drain the oil. Refill with approximately 1.7 pint (800 cc)

Long Term Storage

„„Slide the throttle lever to the STOP position. „„Drain any fuel including in the fuel hose.

„„Replace lubrication oil and apply grease to lubrication points.

„„Cover the air intake on the air cleaner and the exhaust outlet on the muffler.

„„Store unit indoors covered with plastic sheet in moisture free and dust free location out of direct sunlight.

MTX80SD RAMMER • operation and parts manual — rev. #0 (07/20/12) — page 17

Image 17 Contents
Model MTX80SD Proposition 65 warning MTX80SD Rammer operation and parts manual rev. #0 07/20/12 MTX80SD Rammer Table of ContentsChoose from three easy options SaFeTy MeSSageS Safety InformationRaMMeR SaFeTy GeneRal SaFeTyBefore servicing equipment Engine SaFeTyFuel SaFeTy EnviRonMenTal SaFeTy TRanSpoRTing SaFeTySpecifications General Information Drain Valve Open this valve to remove oil from the bellows ComponentsHook Used to lift rammer for transporting Robin ER120D45000 Engine Basic engineCrankcase and Spring Cylinder Oil Bath InspectionEngine General InspectionRepeat steps 1 thru OperationInitial Startup Stopping The Engine OperationLong Term Storage MaintenanceEvery 80 to 100 Hours Troubleshooting engine TroubleshootingAir cleaner dirty? Clean or replace air cleaner Incorrectly set? Oil in excess? Symptom Possible problem SolutionMTX80SD Rammer operation and parts manual rev. #0 07/20/12 Explanation of Code in Remarks Column Suggested Spare Parts Throttle WireSpark Plug STRAINER, #110 Fuel TankNameplates and decals Quick Manual Decal ANTI-VIB HandleDecal Choke Operation Decal E/G Fire Warning75-1 75-2 75-3 Crankcase and engine assyAIR Cleaner Cover Connecting RODBase CP, AIR Cleaner Grip Bolt CP, AIR Cleaner35-8 55-1 35-5 40-1 55-2 40-2 40-3 Wire Harness KNOB, Cleaner CoverBolt 8X55 T WASHER, Flat M8Guide cylinder assy Guide cylinder assy Foot assy BOLT, Square Neck Nylon NUT M12Grip Handlebar Nylon NUT M10Fuel tank and handle assy Socket Head Bolt 10 X 20 T Shock Absorber W/PINHandle CAP ASSY., Fuel TankCombination Lever assy Stop Switch Wire CAPFuel Cock LeverTools Clutch Mounter Clutch Puller aPiston ROD Holder Socket Head Bolt 8X50 Full Thread Crank Gear RemoverRobin er120d45000 engine Crankcase assy Stem Seal Switch OIL PressureOIL Seal Ball BearingRobin er120d45000 engine CRANKSHAFT, piston assy Crankshaft CP Connecting ROD BoltSpacer Flange NUTRobin er120d45000 engine intake, exhaust assy CAM Pulleycp Adjust ScrewValve Spring Spring RetainerRobin er120d45000 engine governor, operation assy Governor Shaft Governor LeverGovernor ROD CP Linkage BushingRobin er120d45000 engine cooling assy Cylinder Baffle X13006034021E52601H3 Robin er120d45000 engine starting assy 210 214 211 213 212 217 216 249Reel Spiral SpringStarter Rope Starter KnobRobin er120d45000 engine fuel lubricant assy Cover Pump Screen InletShaft Throttle Valve ThrottleRobin er120d45000 engine electric device assy FLY Wheel CP Wire BandIgnition Coil CP Screw and Washer AssyFReigHT poliCy Terms and Conditions of Sale PartsMTX80SD Rammer operation and parts manual rev. #0 07/20/12 HERE’S HOW to GET Help