Grundig CDS 6580 SPCD manual General information on laser devices, Troubleshooting

Page 34

CLASS 1

LASER PRODUCT

INFORMATION_____________________________________

General information on laser devices

Your system is a CLASS 1 LASER PRODUCT. This means that the laser is designed in such a way as to ensure that the maximum permissible emission value cannot be exceeded under any circumstances.

Caution:

If operating devices or methods other than those specified here are employed, it may lead to dangerous exposure to emissions.

This device emits laser radiation. Because of the danger of eye injuries, the unit may only be opened or serviced by trained personnel.

If settings other than those specified here are employed or other procedures are carried out, this may lead to dangerous radiation exposure.

Troubleshooting

Not every kind of sound interference is caused by a defect in your hi-fi system. Defects can also be caused by leads having been accidentally pulled out, damaged CDs and worn out batteries in the remote control. If the following measures do not do not rectify the problem, consult an authorised dealer.

Fault

Possible cause/remedy

 

 

No sound.

The volume setting is too low – increase the volume.

 

The headphones are plugged in – disconnect the head-

 

phones.

 

The power cord is incorrectly connected. Connect it

 

properly.

 

Mute is activated, deactivate Mute.

 

 

The hi-fi system does not react when

Static electrical discharge. Switch off the hi-fi system, dis-

the buttons are pressed.

connect the power cable and plug it in again after a few

 

seconds or press »RESET«.

 

 

The remote control does not work.

The batteries are flat. Replace the batteries.

 

The remote control is out of range of the stereo.

 

 

Poor radio reception.

Weak antenna signal, check the antenna.

 

Weak FM-stereo signal, switch to Mono.

 

Interference from electrical devices such as televisions,

 

video recorders, computers, neon lamps, thermostats or

 

motors. Keep the hi-fi system away from such devices.

 

 

Tracks on a CD are skipped.

The CD is damaged or dirty – replace the CD or clean it.

 

The PROGRAM (track memory) or RANDOM functions are

 

active. Deactivate the functions.

 

 

CD-Rs or CD-RWs are not played

Faulty software or hardware settings during burning or the

back, or are played back incorrectly.

CD itself.

 

Check the components of your CD burner/software or

 

change the CD being used.

 

 

34

Page 33 Page 35
Image 34
Page 33 Page 35
Contents Hifi Micro System Tuner mode Set-up and safetySettings CD modeImpossible to remove Using itMagic Fidelity Sound concept from Ovation SplashesControls on the front TUNING/ALBUMHi-fi system controls UP DownON/OFF Volume +Controls on the top SleepUBS DSCAuto Dimmer Controls on the sides Controls on the bottomHi-fi system displays FM frequency indicator Tuner mode an FM stereo station is being receivedMW frequency indicator Text In tuner mode the radio text function is activatedPTY Remote controlTUNER/BAND ColorINTRO/REP FM ModeDisplay PROG./RANDConnecting the headphones Connecting the antennaConnecting an external device Connecting the power cordInserting batteries in the remote control Environmental noteContacting Grundig Consumer Relations 01788 Additional information for units sold in the UKMoulded 3-pin lead set, suitable for UK use 003 Setting the time1202 1203Automatic station search Setting and storing radio stationsManual station search Case of malfunction you can reset the hi-fi system ResetStoring stations on station positions Adjusting the volume Switching the hi-fi system on and offAdjusting the brightness of the display Changing the colour of the display lightingSwitching the display Setting the equaliserSwitching the Ultra Bass System on and off Selecting sound effectsStereo/mono reception Selecting a preset positionSelecting the Tuner input source Automatic station searchRDS time synchronisation RDS station serviceSearching for RDS stations Calling up RDS information1320 Station types PTYSelecting the CD input source No DiscInserting a CD 009115 Playing back a CD001 000Repeating all the files on an album MP3 only Repeating a file or a title Repeat OneRepeating all files or tracks Repeat All Playing the introductions of files or tracks Intro 006Playing back files or tracks in random order Random Press »CD II« to start playbackProg 000 000 ProgCreating a track memory Adding files or tracks Checking the track memoryDeleting the track memory Set the volume using »- Volume +« Switch-on timerSetting the switch-on timer 000 600 6301849 14452316 0934 Reminder timerSleep timer 2359Technical data Cleaning the CD unitEnvironmental note Troubleshooting General information on laser devices
Top Page Image Contents