Troubleshooting
Troubleshooting Guide |
|
| |
Problem | Cause | Correction | |
|
|
|
|
The tape leg on the front of the | The tape is threaded incorrectly | The tape must go around the wrap | |
case is too long |
| roller before going around the | |
|
|
| |
|
| The tape tension is too low | Adjust the |
|
| The knurled roller drags | Check for adhesive |
|
|
| between the knurled roller and its |
|
|
| shaft. Clean and lubricate shaft. |
|
|
| Remove all lubricant from roller |
|
|
| surfaces. |
Tape tracks to one side or drags on the support tabs of applying frame
The
Adjust the tape web alignments
Position the roller in its mounting slot so that the tape extends just beyond the centerline of the applying roller
|
| Taping head is not set up properly | Check leg length adjustments |
|
|
|
|
The blade does not cut tape or the | The blade is dull and/or has | Replace the blade | |
tape end is jagged or shredded | broken teeth |
| |
|
| Tape tension is insufficient | Increase tape tension by adjusting |
|
|
| the |
|
| Adhesive has built up on the blade | Clean and adjust the blade |
|
| The blade is not positioned | Make sure the blade is bottomed |
|
| properly | out against the mounting bolts |
|
| The blade is dry | Lubricate the blade oiler pad on |
|
|
| the blade guard |
|
| The blade is in backwards | Mount the blade so that the |
|
|
| beveled edge is away from the |
|
|
| entrance of the head |
One or both cutter springs are missing or stretched
Tension roller surface is not fully contacting the taping head frame
Replace the defective spring(s)
Make sure
(Continued)
15