Broan 684, 676 warranty Typical Installation, Advertencia, Precaución

Page 1

READ AND SAVE THESE

CEILING VENTILATORS/VENTILADORES DE CIELO RASO

MODELS / MODELOS 676 • 684

To register this product visit

www.broan.com

READ AND SAVE

THESE INSTRUCTIONSS

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

1.Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in the warranty.

2.Before servicing or cleaning unit, switch power off at service panel and lock the service disconnect- ing means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a promi- nent warning device, such as a tag, to the service panel.

3.Installation work and electrical wiring must be done by a qualified person(s) in accordance with all ap- plicable codes and standards, including fire-rated construction codes and standards.

4.Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent backdrafting. Fol- low the heating equipment manufacturer’s guideline and safety standards such as those published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.

5.When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utili- ties.

6.Ducted fans must always be vented to the out- doors.

7.If this unit is to be installed over a tub or shower, it must be marked as appropriate for the application and be connected to a GFCI (Ground Fault Circuit Interrupter) - protected branch circuit.

8.Never place a switch where it can be reached from a tub or shower.

9.This unit must be grounded.

CAUTION !

1.For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors.

2.To avoid motor bearing damage and noisy and/or unbalanced impellers, keep drywall spray, construction dust, etc. off power unit.

3.Please read specification label on product for further information and requirements.

Installer: Leave this manual with the homeowner.

Homeowner: Use and Care information on page 4.

TYPICAL INSTALLATION

POWER CABLE

MOUNTING TABS

CEILING

JOIST

HOUSING

CEILING

MATERIAL GRILLE

Housing mounted directly to joist 2x6 (or larger) Discharge parallel to joists.

POWER CABLE

ADDITIONAL

MOUNTING

FRAMING

*

TABS

 

2 x 4

 

2 x 4

CEILING

CEILING

JOIST or

JOIST or

TRUSS

TRUSS

HOUSING

 

 

CEILING

MATERIAL GRILLE

Housing mounted to 2x4 truss

Requires additional framing for mounting tabs.

Discharge parallel to joists.

 

POWER CABLE

ADDITIONAL

 

 

FRAMING*

 

 

MOUNTING

 

 

TABS

 

 

 

 

HOUSING

 

"I"

CEILING

 

 

"I"

JOIST

MATERIAL

GRILLE

 

JOIST

 

 

 

Housing mounted to “I” joist

Requires additional framing for mounting tabs.

Discharge parallel to joists.

 

4" ROUND

POWER CABLE

DUCT

 

MOUNTING TABS

 

HOUSING

 

 

CEILING

 

ADDITIONAL

CEILING

GRILLE

FRAMING *

MATERIAL

 

JOIST

Housing mounted to additional framing

Discharge 900 to joists.

 

4" ROUND

POWER CABLE

DUCT

 

MOUNTING TABS

 

HOUSING

 

 

 

2 x 4

 

 

ADDITIONAL

2 x 4

CEILING

 

FRAMING

 

CEILING

GRILLE

* CEILING

MATERIAL

 

JOIST or

 

 

 

 

JOIST or

TRUSS

 

 

 

 

TRUSS

Housing mounted to 2x4 truss

Requires additional framing for mounting tabs.

Discharge 900 to joists.

4" ROUND

POWER CABLE

DUCT

MOUNTING TABS

 

HOUSING

 

 

 

 

 

 

ADDITIONAL

"I"

"I"

CEILING

GRILLE

FRAMING

*

JOIST

JOIST

MATERIAL

 

 

 

Housing mounted to “I” joist

Requires additional framing for mounting tabs.

Discharge 900 to joists.

*Additional framing must be a 2x6 (minimum height), at least 9-inches long.

LEA Y CONSERVE ESTA

INSTRUCCIONES

ADVERTENCIA

PARA REDUCIR EL RIESGO DE INCENDIO, DES- CARGA ELÉCTRICA O LESIONES PERSONALES, OBSERVE LO SIGUIENTE:

1.Utilice esta unidad solamente de acuerdo con las instrucciones del fabricante. Si tiene preguntas co- muníquese con el fabricante a la dirección o al número telefónico que se indica en la garantía.

2.Antes de dar servicio o limpiar la unidad, interrumpa el suministro de energía en el panel de servicio y bloquee los dispositivos de desconexión para evitar la reinstalación accidental de la energía. Cuando no se puedan bloquear los dispositivos de desconexión, fije seguramente en el panel de servicio un medio de advertencia que sea visible, como por ejemplo una etiqueta.

3.Una persona o personas calificadas deben realizar el trabajo de instalación y el cableado eléctrico, de acuerdo con todos los códigos y normas aplicables, inclusive los códigos y normas de construcción para evitar incendios.

4.Se necesita suficiente aire para que se realice la combustión y la descarga de gases adecuadas a través de la chimenea del equipo para quemar com- bustible a fin de evitar las corrientes de inversión. Observe los lineamientos del fabricante del equipo de calefacción y las normas de seguridad, como por ejemplo las publicadas por la Asociación Nacional de Protección contra Incendios (National Fire Protection Association: NFPA), y la Sociedad Americana de Ingenieros en Calefacción, Refrigeración y Sistemas de Acondicionamiento de Aire (American Society for Heating, Refrigeration and Air Conditioning Engineers: ASHRAE), y los códigos locales.ditioning Engineers (ASHRAE), and the local code authorities.

5.Cuando corte o perfore la pared o el cielo raso, tenga cuidado de no dañar el cableado eléctrico ni otras conexiones de servicios que se encuentren ocultas.

6.Los ventiladores con conductos siempre deben tener salida hacia el exterior.

7.Si se va a instalar esta unidad sobre una tina o ducha, debe marcarse que es apropiada para esta aplicación y conectarse a un GFCI (interruptor accionado por pér- dida de conexión a tierra) en un circuito de derivación protegido.

8.Nunca coloque el interruptor en un lugar en donde se pueda alcanzar desde la tina o ducha.

9.Esta unidad debe conectarse a tierra.

PRECAUCIÓN !

1.Esta unidad debe usarse solamente para ventilación general. No la utilice para la descarga de materiales ni vapores peligrosos o explosivos.

2.Para evitar causar daño a los cojinetes del motor y pistones impulsores ruidosos y/o no balanceados, mantenga los aerosoles para pirca, el polvo de construcción, etc. lejos del motor.

3.Por favor consulte la información y los requerimientos adicionales contenidos en la etiqueta de especifica- ciones que se encuentra en el producto.

A la persona que realiza la instalación: Deje este manual con el dueño de la casa.

Al dueño de la casa: Las instrucciones de operación y limpieza se encuentran en la página 4.

Image 1
Contents Advertencia Typical InstallationPrecaución Install the Housing Typical InstallationsInstalaciones Típicas Connect the Wiring Install the DuctworkAttach the Grille Conexión EléctricaService PARTS/PIEZAS DE Servico WarrantyUSE and Care Garantia

676, 684 specifications

The Broan 676 and 684 range hoods are essential additions to modern kitchens, marrying functionality with sleek design. These range hoods are engineered to enhance ventilation, eliminate odors, and improve air quality, all while complementing contemporary kitchen aesthetics.

One of the key features of both models is their powerful ventilation system. The Broan 676 and 684 are equipped with robust motors that deliver efficient airflow, allowing for the effective expulsion of smoke, steam, and cooking odors. The adjustable fan speeds provide versatility, enabling users to customize airflow to suit their cooking needs, whether they’re simmering sauces or searing meats.

In terms of design, both models showcase a streamlined look that seamlessly fits into various kitchen décors. Available in multiple finishes, including stainless steel, they offer a professional touch while ensuring durability and easy maintenance. The compact design also maximizes space, making them ideal for kitchens of all sizes.

Technologically, the Broan 676 and 684 feature easy-to-use controls that allow for quick adjustments. Many users appreciate the inclusion of variable speed settings, which provide enhanced control over the extraction power. The integrated lighting is another highlight; it offers bright, efficient illumination over the cooking area, making it easier to monitor food as it cooks.

Noise levels are often a concern with range hoods, but both the Broan 676 and 684 operate quietly, ensuring a peaceful cooking environment. The engineers at Broan have focused on sound reduction features, allowing for ventilation without the typical noise associated with range hoods.

Installation of the Broan range hoods is straightforward, with a comprehensive mounting system that allows for different configurations, whether for under-cabinet, wall-mounted, or ducted applications. This flexibility ensures that homeowners have options suitable for their specific kitchen layouts.

Overall, the Broan 676 and 684 range hoods epitomize a blend of performance, style, and convenience. Their powerful ventilation capabilities, stylish designs, advanced technology, and user-friendly features make them excellent choices for anyone looking to enhance their cooking experience while maintaining a fresh and clean kitchen environment.