Casablanca Fan Company Casablanca 19th Century manual Intelitouch Installing the W-32 Wall Control

3. Do not use more than one fan per wall control.

4. No other light fixtures or electrical appliances may be con- nected on the circuit controlled by the W-32 wall control unit.

INTELI•TOUCH © INSTALLING THE W-32 WALL CONTROL

The wall control installs in the same manner as an ordinary light switch, using an existing junction box and wiring. This controller is designed to signal the fan microcomputer as well as perform normal switching operations. For this reason the following precautions must be observed:

1. Use only the Casablanca W-32 wall control.

2. Do not use any additional control with your Inteli-Touch fan (for example, dimmer, fan speed control, etc.).

INTELI•TOUCH ♦ SINGLE W-32 INSTALLATION

CAUTION! Ensure power is turned OFF at the breaker or fuse panel before starting installation.

W-32 is used to describe either white (-11) or ivory finish.

1.Remove the screws and switch plate from the existing switch box.

2.Remove the screws holding the switch in the switch box.

3.Pull the existing switch from the switch box to expose the wire connections.

4.Remove the two wires from the switch.

5.Connect the two wires just removed from the switch to the W-32 wall control black wire and black/white stripe wire. Secure these connections with wire nuts.

6.Install the W-32 in the wall box with the two long screws provided.

7.Install the wall plate with the two color matched screws.

NOTE: If your wall control operation is reversed, i.e., fan switch controls lights and light switch controls fan, simply swap the two W-32 black/white stripe wires.

SWAP THESE

TWO WIRES WHEN

NECESSARY

(SEE NOTE BELOW)

INTELI•TOUCH ♦DUAL W-32 INSTALLATION

CAUTION! Ensure power is turned OFF at the breaker			SWAP THESE TWO WIRES
or fuse panel before starting installation.
			WHEN NECESSARY
To control the fan and lights from two locations			(SEE NOTE BELOW)
(a three-way circuit), use 2 W-32 wall controls.
1.	Remove the screws and switch plate from the
	existing switch box and the screws holding
	the switch in the switch box.
2.	Pull the existing switch from the switch box
	to expose the wire connections.
3.	Determine which wire is connected to the com-
	mon terminal of the 3-way switch. (The
	terminal will be marked on switch).
4.	Remove the wire from the common terminal
	of the 3-way switch. Connect this wire to the
	remaining black/white striped wire on the W-
	32 control. Secure this splice with a wire nut.	END
5.	Remove the two remaining wires from the 3-		IN
		OF
	way switch. Connect one of these wires to a		LINE
		LINE
	black wire on the W-32 control. Secure the
	splice with a wire nut. The remaining wire is
	to be connected to the other black wire on
	the W-32. Secure the splice with a wire nut.
6.	Install the W-32 in the wall box with the two
	long screws provided.
7.	Install the wall plate with the two short color-
	matched screws provided.	NOTE: If your wall control operation is reversed, i.e., fan switch
8.	Installation of the second W-32 control is iden-
		controls lights and light switch controls fan, simply swap the
	tical. Repeat steps 1 through 8.
		two W-32 black/white stripe wires.

12