Casablanca Fan Company 54029, 55000, 54022, 54019, 54028, 55001 Troubleshooting, Fan doesn’t work

Page 16

Troubleshooting

?		?
	?	ON
	?

Fan doesn’t work

•Check the circuit breaker to ensure the power is turned on.

•Make sure the blades spin freely.

•Turn off power from the circuit breaker, then loosen the canopy and check all the connections according to the wiring diagram on page 10-11.

•Check the plug connection in the switch housing.

Excessive wobbling

•Tighten all of the blade and blade iron screws until they are snug.

•Turn the power off, support the fan carefully, and check that the hanger ball is properly seated.

•Use the provided balancing kit and instructions to balance the fan.

16

www.CasablancaFanCo.com 1.888.227.2178

CLICK!

CLICK!

CLICK!

Noisy Operation

•Tighten the blade and blade iron screws until they are snug.

•Check to see if any of the blades are cracked. If so, replace all of the blades.

M6002-01 • 06/07/12 • Casablanca Fan Company

Image 16

Contents Table of Contents What to Expect with Your Installation Tools Needed Screwdrivers Power Drill Drill Bit OptionalLadder Pliers Standard Ceiling Mounting Outlet Box Style Required Mounting OptionsFan from a vaulted or angled ceiling See previous Make sure all four 4 bumpers Are still attached Ceiling Bracket InstallationFor angled ceilings, point Opening toward peak Ceiling Bracket Installation Preparation Remove the shipping blocks fromDownrod Remove the pre-installed Hand tighten the downrod at Tighten the setscrewSetscrew so that the downrod Leave at least 8 extendingPut the wires and downrod through FanWiring Canopy Insert the two canopy screws Found Hardware bagBlades Switch Housing Which two screw holes you choose Twist counterclockwiseComing from the switch housing Line up the colored markings onMaintenance & Cleaning To switch the direction of airTroubleshooting Fan doesn’t work