ELECTRICAL CONNECTION
Before connecting the plug to the power outlet, make sure that the voltage of your electrical system corresponds to the voltage shown on the appliance rating label and the outlet you are going to use is in good condition.
INSTALLATION
The appliance may be used on any rigid horizontal surface. Do not overload the electrical circuit; avoid using the same outlet for multiple appliances.
OPERATION AND USE
1.Connect the appliance to the power outlet.
2.The appliance emits a beep and the power indicator light (H) comes on and remains on as long as the appliance is powered.
3.The appliance goes into
4.Press the
5.Press the MODE button (E) to select one of the following functions available:
Heating ( ) , Ventilation ( ) ,
5.1Heating ( )
In this operating mode you can set the desired temperature by pressing the + and - adjust- ment buttons (B) and selecting one of the power levels: MIN, MAX, and AUTO using the
power selector button (D) (). MIN power level:
The appliance operates at the minimum power, reducing noise and energy consumption to the minimum.
MAX power level:
The appliance operates at the maximum power for rapid heating of the room. AUTO power level:
The appliance automatically determines the operating power based on the ambient conditions.
5.2Ventilation ( )
In this operating mode only the fan operates, so the appliance does not heat the room.
Press the power selector button (D) ( ) to select the desired ventilation speed: MIN or MAX.
5.3
In this operating mode the appliance keeps the room at a temperature of 45°F (7°C) to prevent freezing temperatures.
6.If you want the appliance to distribute the airflow over a larger area, press the oscillation button (C) ( ). The appliance will then oscillate right and left. To stop the oscillation in the desired position, just press oscillation button (C) again.
7.To turn off the appliance press the
24-HOUR DIGITAL TIMER
This function can be activated from any operating mode.
NOTE: The display can show the temperature in both °F and °C. To select, press and hold the + key for at least 5 seconds, then release.
Delayed
The display shows the symbol ( ) and the time remaining before
The display returns to showing
during the previous operation.
Delayed
4