Electric Power Connection

Your product is equipped with a polarized alternating current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet.

Do not defeat the safety purpose of the polarized plug.

The fan heater must be connected to a properly polarized A/C 110/120 V household outlet in perfect working condition.

Keep loose clothing or bedding, furniture and flammable material away from the wall outlet where the heater is plugged in.

GFI SAFETY PLUG (APPLIANCE LEAKAGE CURRENT INTERRUPTER)

This device provides protection against electric shock due to ground fault currents by automati- cally shutting off the power. To test the operation of the GFI Safety Plug ,

switch the heater ON at either the 1 or 2 setting. Press the TEST button on the GFI Safety Plug located at the end of the power cord. The heater and fan should stop operating and the Power Light should be extinguished.

Press the RESET button on the GFI Safety Plug to resume normal opera- tion of the heater. This device should not be used as on ON/OFF opera- tion switch.

“CAUTION: ALTHOUGH THIS DEVICE IS PROVIDED WITH PROTECTION WHICH REDUCES THE RISK OF ELECTRIC SHOCK, THIS PRODUCT SHOULD NEVER BE USED CARELESSLY NEAR WATER.”

WALL-MOUNTING INSTALLATION

The appliance must always be wall-mounted and in a vertical position. Assembly time: 15 min

Tools for assembly: screwdriver PH 2 x 100 (not included) list of parts:

The wall mounting kit includes:

1bracket

2x screws

2 x anchors (0. 6x30)

To mount, proceed as follows:

1.Remove the bracket on the back panel by pulling downwards.

2.Choose where you want to install the appliance, making sure that:

a.The plug and socket are easy to reach after installation.

b.Neither power cables or pipes behind the wall can be damaged.

c.The appliance is a safe distance from curtains or inflammable material.

3.Before drilling the wall, mark the exact points as shown in fig. 2.

4.For brick walls, use a 15/64" concrete drill bit. Drill the holes and insert the anchors sup- plied. If mounting on plasterboard, drywall, or hollow walls in general, it is recommended to use a stud-finder to locate the nearest stud on which to mount the bracket for added sta- bility. For these type of walls, use a 15/64" wood drill bit, and drill directly into the stud using the specific anchors (not included)

For any other type of wall, seek the advice of a specialist.

5.Fix the bracket with the two screws provided (fig. 2).

Attach the appliance to the top and bottom hooks of the bracket, then push it gently downwards.