To prevent serious injury
from accidental operation or electric shock:
Before assembly, cleaning or adjustment, make sure the switch is turned off, the cord is unplugged, and the unit has cooled.
Note: For additional information regarding parts listed, refer to Assembly Dia- gram at the back of the manual.
4.Insert the ends of the Stand Base (3) into the Stand Arms.
5.Align the holes in the sides of the Stand pieces and thread the Screws in place.
6.Adjust the body of the fan to the de- sired angle, then Tighten the Adjust- ment Knobs.
Operation
Read the entire RULES FOR SAFE OPERATION section at
Adjustment
Knob (4) 
Stand
Arm (2)
Fan Body (1)
Screw (5)
the beginning of this manual including all text under subheadings therein before set up or use of this product.
1. | Turn the knob on the back of the Fan |
| Body (1) to Off. |
2. | Set the Fan on a dry, stable surface. |
3. | Plug the power cord into a standard |
| 120V AC outlet. |
4. | Turn the Knob on the back of the fan |
| to the desired setting: Low, Medium |
| or High. |
5. | Adjust the tilt of the Fan Body by |
Stand Base (3)
Figure 1
1.Place the Fan Body (1) on a flat and stable surface.
2.Remove the Screws (5) and set aside.
3.Slide the Adjustment Knobs (4) onto the bolts on the Stand Arms (2) and loosen the Stand Arms slightly by turning the Adjustment Knobs counter clockwise.
loosening the Adjustment Knobs (4), |
changing the tilt of the body, then |
tightening the Adjustment Knobs. |
6. When done, turn the Knob on the |
back of the Fan Body to Off and un- |
plug. |
Note: It is normal for the motor of the Fan to feel warm to the touch dur- ing operation. The motor is thermally protected and will automatically shut off when it overheats for any reason. If this happens, immediately discon- nect the Fan from the power outlet.
SKU 66878 | For technical questions, please call | Page 5 |