Sharp HT-SB32D System preparation, Driving screws, Installing the sound bar, Using spike legs

System preparation

Make sure to unplug the AC power lead before in- stalling the sound bar or changing the position.

Using spike legs

1Peel the double sided tape separator.

Spike leg	Double sided
	tape separator

2Fix the spike leg onto the sound bar as shown.

Bottom of sound bar

To mount the sound bar on the wall Caution:

●● Be very careful to prevent the sound bar [2.3 kg (5.1 lbs.)] from falling when mounting on the wall.

●● Before mounting, check the wall strength. (Do not put on the veneer plaster or whitewashed wall. The sound bar may fall.) If unsure, consult a qualified service technician.

●● Mounting screws are not supplied. Use appropri- ate ones.

●● Check all wall mount angle screws for looseness. ●● Select a good location. If not, accidents may occur

or the sound bar may get damaged.

●● SHARP is not responsible for accidents result- ing from improper installation.

■■ Driving screws

SHARP designed the sound bar so you may hang it on the wall. Use proper screws (not supplied). See below for size and type.

	3.2 mm
5 mm	9 mm
	22 mm

■■ Installing the sound bar

1Fix the pattern paper to the wall in hori- zontal position as below.

548509mmmm

Wall surface 44 mm

Pattern paper (supplied)

2Make a hole on the wall following the screw point marks on the pattern paper by using a drill.

32 mm

8-9 mm

Wall surface

3Fix a wall mount plug into the hole using a hammer, until it is flush with the wall surface.

32 mm

8-9 mm

Wall surface

4Fastenthescrewstothewallasshownbelow. (Total screw is 2 pieces)

	Screw using
Wall surface	screwdriver
	4.5 mm - 5 mm
Wall surface	Gap from wall
	surface

5Hang the sound bar onto the screws.

6