ASSEMBLY INSTRUCTIONS
•Place the metal stand fan pole into the base extension, lining up the groove of the pole to the hole in the base extension.
•Push together until the holes (in the groove) line up (Fig. 2).
•Insert and hand tighten the locking thumb screw.
•Place the fan assembly over the metal stand pole while lining up the groove from the fan assembly with the hole in the fan pole. Push together and line up the holes (Fig. 3).
•Insert the fan locking thumb screw and hand tighten.
•Unscrew the control box locking knob from the control box.
•Push the control box extension through the hole in the fan pole (Fig. 4). Be sure that the power cord from the control box to the fan is always free hanging.
•From the rear, tighten the control box holding knob.
DO NOT OVERTIGHTEN.
Fig. 2
➡
➡
Fig. 3
➡ ➡
Fig. 4
Commercial |
|
Grade | ➡ |
|
OPERATION
•Set your fan on a level, dry surface.
•Plug the power cord into a grounded three prong wall outlet.
•Select the desired speed for your needs
•Tilt the fan assembly to the desired air direction.
•For maximum circulation, you may point the fan toward the
ceiling and get the maximum air turbulence (Fig. 5). Using this method in the summer will circulate air providing a “wind chill” effect, and in the winter will move the warm air from the ceiling, dispersing it and giving you a more uniform room temperature.
Fig. 5