VXI B200 manual

PAIRING See page 6 for location of button controls.

For your convenience, the BlueParrott B200 base and headset have been paired in advance at the factory. However, if you have since paired the headset or the base with an alternate Bluetooth product, you will need to pair the BlueParrott B200 base and headset together again.

Before Pairing: Take the Headset and Base Out of Standby Mode (page 14)

Note: Be sure the headset is off the base

To take the B200 headset out of Standby Mode: Press and hold down the multifunc- tion button for about 4 seconds. You will hear 3 beeps in the headset that descend in tone and the yellow light on the headset will stop flashing.

To take the B200 base out of Standby Mode: Press and hold down the pairing button for about 4 seconds. The yellow light on the base will stop flashing.

Pair the BlueParrott B200 Base With The BlueParrott B200 Headset

Be sure the headset is off the base and both are out of Standby Mode (see “Before Pairing” above”).

1.Turn off all other Bluetooth products or keep them at least 50 feet away.

2.Position the B200 base and B200 headset no more than 3 feet apart.

3.Press and hold down the pairing button on the B200 base for approximately 5 to 10 seconds. The yellow light will flash, followed by the red and yellow indicator lights flashing alternately. Release the pairing button.

4.Press and hold down the the multifunction button on the B200 headset for about 5-10 seconds until you hear two series of melodic tones (hold it up to your ear). The yellow and red indicator lights on the headset will flash alternately (this hap- pens quickly). Release the multifunction button.

5.The red light will stop flashing on both the headset and the base. The yellow will

continue (indicating Standby Mode). Successful pairing has been completed.

Pair the BlueParrott B200 Base With A Different Bluetooth Headset

See compatibility section of this user guide. Be sure the B200 headset is off the base and both are out of Standby Mode (see “Before Pairing” page 18).

1.Position the B200 base and your alternate headset no more than 3 feet apart.

2.Press and hold down the pairing button on the B200 base for approximately 5 to 10 seconds. The yellow light will flash, followed by the red and yellow indicator lights flashing alternately. Release the pairing button.

3.Follow the alternate headset’s user guide for putting the headset into pairing mode.

4.When the red light on the B200 base stops flashing, pairing has been completed (check your headset user’s manual for pairing confirmation indicators).

Pair the BlueParrott B200 Headset With A Bluetooth Cellular Phone

See compatibility section of this user guide. Be sure the B200 headset is out of the base and both are out of Standby Mode (see “Before Pairing” page 18).

1.Position the B200 headset and your phone no more than 3 feet apart.

2.Press and hold down the the multifunction button on the B200 headset for about 5-10 seconds until you hear two series of melodic tones (hold it up to your ear). The yellow and red indicator lights on the headset will flash alternately (this hap- pens quickly ). Release the multifunction button.

3.Refer to your phone’s user manual for pairing instructions. The phone’s pass code must be set to 0000.

4.When the red indicator light on the B200 headset stops flashing, pairing has been completed (check phone’s user manual for pairing confirmation indicators).

18	19