Honeywell HS-160R owner manual Cross Base, Assembly Instructions

ASSEMBLY INSTRUCTIONS

	REAR GRILLE		REAR GRILLE (E)
	MOUNTING
	NUT (D)
BLADE KNOB (F)
CLIPS
(G)				MOTOR HOUSING
				MANUAL CONTROL
				PANEL
GRILLE	FAN BLADE	REMOTE CONTROL
HUB
			METAL	BASE
FRONT GRILLE			POLE (C)	CONNECTOR (B)
METAL
POLE
	BASE EXTENSIONS
	(A)
BASE
ROUND BASE			CROSS BASE

First look to see if your fan has a cross base or a round base, and then follow the base assembly instructions for the fan you have.

FOR CROSS BASE

•Place Base Extensions (A) as illustrated and push down hard to snap Base Connector (B) firmly onto Base Extensions (A) (Fig. 1).

•Insert the Metal Pole (C) into the Base by lining up the recessed slot in the Pole to the raised dot on the Base Connector and push in. Be sure that the Pole is fully seated. Hold the Base firmly and twist the Pole CLOCKWISE 90° until it stops. DO NOT OVER-TIGHTEN (Fig. 2).

Fig. 1

B

A

Fig. 2

C

RECESSED

SLOT

FOR ROUND BASE

•Insert the Metal Pole (C) into the Base by lining up the recessed slot in the Pole to the raised dot on the inside of Base and push in (Fig. 3). Be sure that the Pole is fully seated. Hold the Base firmly and twist the Pole CLOCKWISE 90˚ until it stops. DO NOT OVER-TIGHTEN.

Fig. 3

C

RECESSED

SLOT