HOW TO MAINTAIN
The instructions given in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls check the belt and brush roll often. Replace the belt if it is stretched or cracked and clean the brush roll bristles when they are wrapped with thread and hair.
Brush Roll Belt and Headlight
The brush roll belt on the motorized nozzle drives the brush roll to agitate, sweep, and comb the carpet nap. The belt should be checked regularly to be sure that it is in good condition. Replace the belt if it is stretching, cracking, or slipping. Cut away any hair or thread wound around the brush roll or belt pulleys because the buildup could cause the belt to rotate unevenly.
How to Replace Worn Belt or Headlight Bulb
NOTE: Disconnect power cord and wands from electrical hose before replacing belt or bulb. Belt pulleys can become hot during normal use. To prevent burns, avoid touching the belt pulley when servicing the drive belt.
4. Return brush roll into base.
1.Remove two screws from bottom side. Turn over to grasp hood by handle socket and lift forward.
Replace headlight bulb, if necessary. Use GENUINE
EUREKA 25 watt replacement bulb 40009A. Continue to step 2 to change belt. Skip to step 7 and 8 to replace hood on motorized nozzle.
5.Rotate belt onto motor pulley.
6.Replace brush roll cover.
2.Remove two screws located in front of the light bulb and lift up to remove the brush roll cover.
Motor
Pulley
3.Lift out brush roll; replace new belt around brush roll pulley.
Ridge
7.Tilt cover over ridge and push down.
8.Secure with screws on underside (refer to 1).
GENUINE
Look for the EUREKA PRODUCT symbol.
Use GENUINE EUREKA replacement belt, 52201A.
7