How to clear a blockage
! Make sure vacuum is turned off and power cord is unplugged.
Hose blockage
•Remove hose from hose retainer. Flex the hose to loosen any blockage (Fig.1).
•Remove dust cup. Set air path knob to ‘floors.’ Use finger to check for debris (Fig 2).
•Base hose – Pull down to loosen end of base hose. Use finger to clear blockage.
Snap hose end back up into position (Fig 3).
•Hose connector – Pull out on left side tab to remove connector. Remove debris. Align tab at right and snap connector back into place (Fig. 4).
Fig. 1 |
|
Fig. 2 | Fig. 3 |
Fig. 4 |
How to maintain your vacuum cleaner
! Make sure vacuum cleaner is turned off and power cord is unplugged.
Maintain brush roll
Motor pulley can become hot with normal use.
How to clean brush roll
Check brush roll periodically and remove debris. Use scissors to clip threads or hair (Fig. 1).
How to replace brush roll
•Lay vacuum with back on floor. Remove 3 screws (Fig. 2). Rotate brush roll plate up and lift off.
•Rotate brush roll to remove (Fig. 3).
•To install brush roll, align star end first (Fig. 4), then position opposite end. Rotate to make sure brush roll fits securely.
•Replace brush roll plate: Align rounded ends in slots and rotate plate down over brush roll.
•Press plate tightly, making sure 4 hooks latch around rod (Fig. 5).
•Replace 3 screws (Fig. 6).
Fig.1 |
Fig.3 |
Fig.5 |
Fig.2 |
Fig.4 |
Fig.6 |
4Eureka Customer Service HELPLINE
www.eureka.com |