Eureka 6877, 6899, 6750, 6799 warranty Unpacking Assembling, Button Tab SlotHandle

Cyclonic Bag Saver available with some models.

To assemble the cleaner with this option

follow these instructions.

Fig. 1 1

3

2

Fig. 1a

Fig. 2a

Button

Fig. 2b

Tab &

SlotHandle

This accessory reduces the need for frequent bag changes. It does not eliminate the use of a paper bag. To remove the Cyclonic Bag Saver, follow the steps in reverse and reattach the large upper wand.

UNPACKING AND

ASSEMBLING

Unpack and check that all the parts are included. The Cyclonic Bag Saver consists of three main parts, see Fig.1:

1.Cyclonic Housing

2.Cyclone Dust Cup

3.Retaining Clip

Attach retaining clip onto the rear of the cyclonic cup as shown in Fig. 1a.

Attaching the Cyclonic Bag Saver onto the vacuum cleaner

NOTE: If the two long wands have already been assembled to the powerhead, remove the long upper wand to assemble the Cyclonic Bag Saver.

Your vacuum cleaner is equipped with three wands. Locate the short wand.

Fig. 2a Line up the small hole at the top of the short wand with the arrow on the front of the cyclonic housing. Push the short wand into the top of the cyclonic housing until button clicks into place. (You may need to rotate the wand slightly.)

Fig. 2b Attach the cyclonic dust cup onto the cyclonic housing. Place the slot in the cyclonic dust cup over the tab on the cyclonic housing. Then grasp the handle on the cyclonic dust cup, and pivot the cyclonic dust cup up and over the ledge on the cyclonic housing.

9