Eureka 6992 How to Replace Worn Belt or Light Bulb, Brush, to replace hood on motorized nozzle

How To Change or Clean Washable HEPA Filter and Final Filter (Model 6996 only)

Final Filter

(underneath

side)

Open filter cover by lifting up on	Clean or replace washable HEPA
latches and pulling filter cover out	filter. Clean or replace final filter in
and away from the cleaner.	filter cover and close cover.

Use GENUINE EUREKA washable HEPA filter, 61053. To clean filter rinse dirty side of filter under warm, low pressure water being careful not to get the clean side wet (this increases drying time). Do not put damp filter back in vacuum cleaner. Allow to thoroughly air dry.

Ensure the filter cover is securely fastened.

Use GENUINE EUREKA Final filter, 61262. The final filter can be cleaned. Run under water and allow to thoroughly air dry.

How to Replace Worn Belt or Light Bulb

NOTE: Disconnect power cord and wands from electrical hose before replacing belt or bulb. Belt pulleys can become hot during normal use. To prevent burns, avoid touching the belt pulley when servicing the drive belt.

	4. Return brush
	roll into base.
1. Remove two screws from bottom side. To turn over,
grasp hood near handle socket and lift forward.
Replace headlight bulb (on some models), if necessary.
Support socket with one hand and push light bulb into
socket; turn to release. Place new light bulb into socket;
turn to secure. Push light bulb and socket back so bulb
will not touch lens cover. Use GENUINE EUREKA
replacement bulb, 59224.	Brush
Continue to step 2 to change belt. Skip to step 7	Roll
	Pulley
and 8 to replace hood on motorized nozzle.
	5. Rotate belt onto motor pulley.
	6. Replace brush roll cover.

2.Remove two screws located in front of the light bulb and lift up to remove the brush roll cover.

7. Tilt cover over ridge and push down.

8. Secure with screws on underside (refer to 1).

3.Lift out brush roll; replace new belt around brush roll shaft.

Use GENUINE EUREKA replacement belt, 52201C.

9