Euro-Pro EP664 owner manual Operating Instructions, Inserting the Vacuum Handle into the Hand Vac

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS

Warning: Always remove the power plug from the wall outlet before assembling or removing accessories.

Inserting the Vacuum Handle into the Hand Vac

•Push down on the vacuum handle release button then insert the vacuum handle into the opening above the hand vac handle. (Fig. 1)

Handle Release Button Vacuum Handle

Fig. 1

•To remove the vacuum handle, press down on the vacuum handle release button and pull the pole up while securely holding the hand vac handle. (Fig. 2)

Vacuum

Handle

Release

Button

Fig. 2

Attaching the Floor Nozzle to the Hand Vac

•Insert the floor brush into the air intake opening.

•To remove the floor nozzle from the hand vac, pull the floor nozzle straight out from the hand vac.

(Fig. 3)

Attaching the Crevice Brush to the Hand Vac

•Hold the end of the crevice brush. Insert the crevice brush into the air intake opening of the unit. (Fig. 4)

Fig. 4

•For a longer reach the crevice brush can be used with the unit assembled as a

stick vacuum.	Fig. 5
(Fig. 5)

•To remove the dusting brush pull straight out from the air intake opening.

Winding & Unwinding the Power Cord

This unit is equipped with a convenient

cord storage feature. The power cord winds around the two cord holders at the back of the unit. The top one has a quick cord release feature. Turn the cord holder

to the left or the right

to remove the power cord. Fig. 6 (Fig. 6)

On/Off Switch

• The On/Off switch has two different

positions.

• Push on the "I" side to turn the

vacuum ON.

• Push on the "O" side to turn the

vacuum OFF.

= OFF

Using the Unit as an Upright

•Ensure that the dust cup filter is installed in the dust cup container.

•Unwind the power cord and plug into the 120V outlet.

•Press the On/Off switch to the On position and vacuum.

Note: When vacuuming deep pile carpets or hard to vacuum carpets, lower the angle of the vacuum handle (see illustration at right) for easier maneuverability.

Important: Do

NOT use the

vacuum without the filter in place.

Using the Unit as a Hand Vacuum

•Ensure that the unit is unplugged before removing parts, or performing maintenance.

•Press the vacuum handle release button and pull handle to remove.

•Pull the floor nozzle out from the hand vac.

•Attach the crevice brush to the end of the hand vac if desired.

•Press the On/Off switch to the on position to vacuum.

Changing & Cleaning the Dust Cup Filter

To achieve the best performance, empty the dust cup container and clean the dust cup filter after each use.

1.To remove the dust cup container, press down on the dust cup release button and pull off the dust cup container. (Fig. 7)

Dust Cup

Release Button

2.Empty the dust from the dust cup container. (Fig. 8)

Fig. 8

3. Pull off the dust cup filter. (Fig. 9)

Fig. 9

4.Rinse the dust cup filter in cold water, and then wait until it air dries completely before replacing it back into the dust cup container. Do not use a washing machine to clean the dust cup filter. Do not use a hair dryer to dry it. Air dry only.

5.Replace the dust cup filter carefully into the dust cup container. NEVER operate vacuum cleaner without dust cup filter in place.

6.Attach the dust cup container to the vacuum.

Note: It is recommended that the dust cup filter be replaced every three (3) to six (6) months to ensure peak performance of the unit.

Caution: The suction hole must be open and free of any obstructions at all times. Otherwise, the motor will overheat and could become damaged.

Fig. 3

= ON

4

Fig. 7

5