Euro-Pro CW240 owner manual Operating Instructions, Assembling the Base Casters

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS cont.

NOTE: Always remove the power plug from the wall outlet before assembling or removing accessories.

1.Add 6 to 8 cups of water to the tank.

2.Attach the flexible hose to the suction hole.

3.Attach one of the extension tubes to the hand grip of the flexible hose. Insert the hand grip into the wider end of the extension tube and turn to tighten the connection.

4.Attach the other extension tubes to the first one and turn to tighten the connection.

5.Attach the desired accessory (brush with squeegee, air driven turbo brush or floor to carpet brush) to the narrow end of the extension tube.

Assembling the Base Casters

The casters for the base on your new Bagless Water Filtration Vacuum are packed and shipped unassembled. To assemble the caster to the base, simply insert the caster stem into one of the four (4) holes in the base and push downward with the palm of your hand. (See illustration below.) Repeat for the next three (3) casters.

Your CW240 Water Filtration Vacuum may also be used as a wet pick-up vacuum. To use as a wet pick-up vacuum, operate the unit on the wet surface as you would for a dry surface.

NOTE: The air driven turbo brush may not be used for wet pick-up. It is important to monitor the water level in the tank when using the unit for wet pick-up to avoid filling water tank over the "Max" level. "MAX" pick-up capacity is 8 cups or 64 fl. oz.

WARNING: Water level MUST NEVER exceed the "Max" level indicated on the water tank. Empty tank when water level reaches "MAX" indicator. If water is seen to be coming from the exhaust - immediately turn the unit off and unplug from electrical outlet. Empty water tank and clean. Refill water tank with clean water to the "MIN" level, then plug unit back in and continue working.

Using Your Bagless Water Filtration Vacuum

IMPORTANT: DO NOT operate this vacuum when water level is below the "Min" line on the water tank.

1. Unwrap the power cord to the

desired length.

2. Insert plug into electrical outlet.

3. Turn the "On/Off" Switch to the "On"

position.

4. The speed control knob can be used

to adjust the suction. The manual

variable suction control on the hand

grip can be used to further reduce

the suction.

5. Keep the flat space between the

floor brush and floor surface, hand

grip and extension tube and move

Using the Deluxe and Compact Air Driven Turbo Brushes

1.Turn off the vacuum and unplug from wall outlet.

2.Attach the Air Driven Turbo Brush to the extension tube.

3.Re-plug the vacuum into the wall outlet and start the vacuum. Beater bar on the Air Driven Turbo Brush will begin to rotate and will continue to operate as long as the vacuum is “ON”.

4.The Deluxe Air Driven Turbo Brush is adjustable for carpet nap. The Compact Turbo Brush is not. To adjust for high pile carpet, move the slide control on top of the brush housing as shown in Fig. 1.

5.For low nap adjust the slide control as shown in fig. 2.

IMPORTANT: Do not use the Air Driven Turbo Brush for wet pick-up. Use ONLY for dry floors or carpets.

Fig. 2

Fig. 1

Slide	Slide
For high pile carpet	For low nap carpet

Cleaning the Compact Air Driven Turbo Brush

Locking Latch

Tilt

Upwards

Turbine

1.Slide locking latch forward then tilt the top housing of the brush upwards. The top housing is hinged and will tilt up approximately 45°only.

2.Inspect turbine wheel and air passage for debris and/or blockage. Remove debris if present.

3.Inspect the rotating brush for built-up hair or string. If present, remove by carefully cutting with scissors. Avoid damaging or cutting bristles.

4.Once clean, close the top cover of the turbo brush and slide the locking latch toward the rear of the brush to lock.

WARNING: These air driven turbo brushes rotate with the force of the suction power. As the water tank fills with dirt, the suction power will reduce and the air driven turbo brushes will slow down. If this happens, empty the water tank and verify that no threads or hairs have accumulated on the beater brushes which can also reduce beater brush rotation speed.

the vacuum cleaner up and down.

6. When finished using the unit, unplug

from electrical outlet and wrap the

power cord around the top of the

unit.

Compact Air Driven Turbo Brush

WARNING: The beater brush of this floor attachment rotates very fast. To avoid injury, DO NOT TOUCH the beater brush with fingers while the brush is rotating.

3 4