cleaner description
16
\
ld
Operate cleaner only at voltage specified on data plate on bottom of cleaner. This cleaner is intended for household use.
The assembled cleaner will look like the drawing.
1.Handte
2.ONIDFF switch
3.Cord hooks: wrap cord around hooks for storage. The top hook can be rotated right or left for easy cord release.
4.Furniture nozzle
5.Dusting brush
6.Crevice tool
7.Tool cover
8.Bag door latch
9.Bag door
10.Final filter door*
11.Stair cleaning handle
12.Hood
13.Carpet height control
14.Soft GuardTM protector: provides extra protection for your fine furniture.
15.Headlight
16.Hose
17.Extension wand
18.Extra belt* storage
19.Extra bag* storage
20.Handle release lever
*some models only
ON-OFF switch
To turn cleaner ON, push switch (A) up. To turn cleaner Off, push switch down.
Note: To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
To insure that the filter bag is inflated, plug cord into electrical outlet and turn cleaner
ON. With handle in upright position, pull back on handle until front of cleaner(B) is lifted off the carpet.
Hose end must be firmly pushed into “cup” in tool rack for maximum suction on floors.
Handle positions
The handle of your cleaner has three positions; upright for storage and when using cleaning tools; operating for general operation on carpet and floors; low for reaching under low furniture. Step on handle release lever to lower handle.
TLansporting cleaner
To move your cleaner from room to room, pot handle in upright position, tilt cleaner back on rear wheels, and push
The cleaner can also be moved by lifting it as shown in (B).