Hoover 1100 manual Throw-Away Bag, When to Replace the BAG

Check Nozzle Hose (cont.)

throw-away bag being full of fluff from a new carpet, put a new throw-away bag on the cleaner. Then place handle in storage position, turn cleaner on, and move lever on Suction Control Dial back and forth. This will clear the hose.

2. Check Secondary Filter

The secondary filter protects the motor from dirt. Before installing a new bag, check the filter . Dirt spilled in the bag housing will accumulate on the filter and may restrict motor performance. To clean filter, remove wire holder and lift out filter. Tap against a hard sur- face, or rinse thoroughly with warm water and dry . Replace in bag housing and secure with holder.

3. Check Bag (See Below.) 4. Check Belt (Page 11.)

5. Check Agitator Brushes (Page 12.)

THE THROW-AWAY BAG

To assure that your Hoover cleaner operates at peak performance it is imperative that you use only genuine Hoover Throw-Away Filter Bags made by The Hoover Company. Genuine Hoover bags can be identified by the

Hoover Medallion. These bags are made OOJf P from a special material which is scien- @ tifically formulated to filter out dust

while allowing air to flow through freely.

The use of other than genuine Hoover bags voids your guarantee !

WHEN TO REPLACE THE BAG

Check the bag from time to time. When bag is approximately three-fourths full of dirt, it should be changed. If you let more dirt than this accum- ulate, your cleaner will not operate efficiently. Be sure that throw-away bag is not extending outside of cover and that cover is in proper position on the gasket before latching.

9

i