E | ||
| D |
|
C |
C |
Cleaning the filter
The dirt cup filter (D) is located under the dirt cup lid.
When the filter needs to be cleaned, the red light (E) will come on.
Grasp the filter and rotate
If desired, the filter may be rinsed by running it under cold tap water. Do not use soap or detergent. Shake excess water from filter and allow to dry thor- oughly before replacing it in cleaner. Replace the filter by lining up tabs on fil- ter with grooves on lid and rotating clockwise.
If the red light is still on after the filter has been cleaned, there may be a blockage in the hose or wands. Refer to “If you have a problem” section.
Washing the dirt cup
Turn cleaner off and disconnect from electrical outlet.
Remove the dirt cup by pressing the but- ton on the top of the cleaner and pulling the cup straight out. Remove lid. The cup may be rinsed by running it under cold tap water and dried with a soft cloth. Do not replace dirt cup on cleaner unless it has been dried thoroughly. Should the dirt cup platform flaps (C) become dislodged, refit using the dia- gram on the platform.
F |
G |
Exhaust filter
How to clean
Turn cleaner off and disconnect from electrical outlet.
The exhaust filter, located behind the grill on the body of the cleaner, is wash- able. To clean, rotate grill (F) counter- clockwise. Remove the exhaust filter (G). Wash filter by running it under cold tap water. Do not use soap or detergent. Do not use the small brush to clean this filter, as brushing will damage the effectiveness of the filter. Allow to dry thoroughly before replacing on cleaner.
The exhaust filter should be cleaned at least once a year. The filter may become discolored with use, but the filtration effi- ciency will not be affected.
Belt replacement
The belt in your power nozzle drives the agitator. It has been designed specifical- ly for use in this cleaner and is important for effective operation.
What to buy
There are other belts manufactured that are similar in shape and size, but are not designed for the HOOVER power nozzle.
Such belts do not operate the agitator cor- rectly and may create stress which could damage your power nozzle. Use only a genuine HOOVER Belt part no. 40201180 when a belt replacement is necessary.
When to replace
The belt should be checked from time to time to be sure it is in good condition. To check, remove the nozzle cover (see fol- lowing section). Replace the belt if it is stretched, cut, or broken.
How to replace
Disconnect cleaner from electrical outlet and disconnect power nozzle from extension wands.
To remove hood, turn nozzle over and unscrew the 4 recessed Phillips head screws.
Note: Do not remove the 3 screws in the triangle formation as these hold the motor in place.
Continued ➟ | 7 |