Electrolux S670 warranty Brush Roll, How To Replace Worn Brush Strips, PN, Quick Kleen Fan Chamber

Brush Roll

The rotating brush roll sweeps and combs the carpet nap. Keep the brush roll free from hair and threads so it will continue brushing. When the bristles of the brush roll no longer touch a straight edge held across the bottom plate, the brush roll is ineffective because the bristles no longer touch the carpet nap. To maintain the most effective cleaning, replace the wood brush roll. Install new brush strips on the chromed steel brush roll (refer to instructions).

How To Replace Worn Brush Strips, PN 52282-4

(chromed steel brush roll)

CAUTION: Turn off the switch and unplug the electrical cord before replacing brush strips.

New brush strips are supplied in sets of two, one long and one short. To replace, remove bottom plate and belt (see How To Change Belt). Then, grasp center of brush roll and lift to remove.

				G
				F
A	B	C	D	E
Note:					E
Shaft washer (D) not included in ball bearing brush roll assembly.

Quick Kleen® Fan Chamber

(On some models)

CAUTION: Turn off the switch and unplug the electrical cord before cleaning.

The clear, removable fan chamber cover provides easy inspection, cleaning, and maintenance of the fan chamber. Removing the cover provides easy access to the motor fan. Grease buildup, dirt, or other obstructions, visible through the fan cover, should be removed. To clean the fan area, take off the chrome bottom plate by releasing the two cam locks (see Brush Roll Belt, Figure 1 and 2). Remove the belt from, the motor pulley,

A.Remove rubber end cap cover (available on select models) from one end.

B.Unscrew locknut.

C.Remove end cap.

D.Remove shaft washer (not included in ball bearing brush roll).

E.Remove bearing retainer.

F.Push shaft through opposite end.

G.Pull out worn brush strip with pliers.

G. Slide in new brush strip of same length (rounded end first). Fit track on either side into brush roll slot. Replace second brush strip from opposite end of brush roll.

F. Replace shaft.

E. Align indentation on bearing retainer with brush strip on both ends of brush roll.

D. Replace shaft washer.

C. Position end cap with fl at sides of center hole over fl at sides of threaded shaft.

B. Tighten locknut.

A. Align holes and secure rubber end cap cover fl at side against end cap.

then loosen and remove the screws on either side of the fan cover, as indicated by the arrows. Push the cam locks outward against the wheels to lift the cover from the cleaner base. Dirt and obstructions can easily be cleared; however, caked grease may need to be scraped from the cover and the cleaner. If the fan does not turn freely, it also should be removed for cleaning. To remove the fan, place a wrench over the motor pulley. Hold the fan blades with one hand and turn the wrench counterclockwise. Remove the motor pulley and lift the fan off the motor shaft. Clean the area and replace the fan over the motor shaft. Tighten the motor pulley snugly clockwise with the wrench. If necessary, replace the fan cover or the gasket with replacement parts.

When properly assembled, the brush roll should rotate freely between the two end caps. Check the condition of the belt; change if necessary. Replace the brush roll, belt, and bottom plate (see How To Replace A Worn Belt).

Ask for GENUINE EUREKA replacement brush strip. 12 inch No. 52282-4.

Be sure the gasket is in place. Reposition the fan cover by fi rst placing the exhaust end into place between the large rear wheels. Seat fan cover fi rmly. Next replace the belt and bottom plate as the pressure from the bottom plate helps seal the fan cover. Start the two screws by hand to be sure they are straight, then tighten.

Order fan chamber cover replacement kit (fan cover, gasket, two screws) Part No. 52334.

6