Routine Maintenance (continued)
Installing New Dustbag Ref: ES82 | How To Replace Brushroll Belt |
| |
(Alternate bag is E82) |
|
1. Lower handle to floor to change belt.
Fold dustbag cardboard flap at top back.
Make sure dirt inlet goes completely into dustbag and bag is pushed completely back into place. Tuck excess bag into cleaner.
Replace dustbag cover on unit.
CAUTION: Dustbag cover cannot be closed unless the dustbag is installed properly.
2. Remove the two screws from the top of the hood.
3. Lift hood to remove.
Periodic Maintenance
CAUTION: Turn off the switch and unplug the electrical cord before periodic maintenance. Never operate the vacuum cleaner without the dustbag or filter assembly in place.
Brushroll
The brushroll turns as it sweeps and combs the carpet pile. Remove hair and threads from the brushroll so it continues brushing the carpet. To maintain the most efficient cleaning, the bristles must touch the carpet.
Brushroll Belt (Ref: ZE090)
The brushroll belt turns the brushroll to agitate, sweep, and comb the carpet pile. Check the belt regularly to be sure it is in good condition. Replace the belt if it stretches, cracks or loses tension. Cut away any hair or threads wound around the brushroll or the belt pulley because the buildup could cause the belt to rotate unevenly.
WARNING: Care should be taken when vacuuming rugs to ensure that edges and fringes do not snap the drive belt and stop the rotation of the brushroll.
4.Lift left end of brushroll.
5.Remove and discard belt.
6.Place new belt around motor shaft.
7.Place new belt around brushroll pulley.
8.Align left end cap with base. Push end cap securely into place.
9.Pull right side of brushroll to stretch belt. Secure right end cap into base.
IMPORTANT
10. Rotate brushroll by hand two full rotations to properly position belt.
11. Place hood back on cleaner. Replace and tighten two screws.
12. Return vacuum to upright position.
7