Philips AZ1220 Power Supply, Supplied accessories, Top and front panels See, Back panel

English Controls

Power Supply

Supplied accessories

AC power cord

Top and front panels (See 1)

1TUNING – tunes to radio stations

2Band selector: LW, MW, FM

– selects wavebands.

3Cassette recorder keys:

; – pauses playback or recording

9/

–stops playback or recording.

–opens the cassette holder.

5or 6 – fast winds/rewinds the tape

1– starts playback

0– starts recording

42; - starts or pauses CD playback.

5SEARCH ∞ § – CD: skips or searches a passage/track backward or forward.

69 – stops CD playback;

–erases a program;

7Cassette door

8SHUFFLE – plays all CD tracks in random order.

9 PROG – programs tracks and reviews the

program

$Source selector : CD, RADIO,

TAPE/OFF

– selects CD, radio or tape source of sound

–switches off the set

%LIFT TO OPEN – opens/closes the CD door

Back panel

^Telescopic antenna - improves FM reception.

&Headphone - 3.5mm stereo headphone jack

*Battery door - open to insert 6 x 1.5V R-14/ UM2/ C-cells.

(AC MAINS - inlet for power cord.

CAUTION

Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation.

This set complies with the radio interference requirements of the European Community.

Power Supply

Whenever convenient, use the power supply cord if you want to conserve battery life. Make sure you remove the plug from the set and wall outlet before inserting batteries.

Batteries (not included)

1Open the battery compartment and insert six batteries, type R-14, UM-2or C-cells, (preferably alkaline) with the correct polarity as indicated by the "+" and "–" symbols inside the compartment.

2Replace the compartment door, making sure the batteries are firmly and correctly in place. The set is now ready to operate.

Batteries contain chemical substances, so they should be disposed of properly.

•Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst:

•Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set.

•When inserting new batteries, do not try to mix old batteries with the new ones.

•Remove the batteries if the set is not to be used for a long time.

2Connect the power cord to the AC POWER/MAINS inlet and the wall socket.The set is now ready for use.

3To switch the set off completely, withdraw the power cord from the wall socket.

•Disconnect the power cord from the wall socket to protect your set during heavy thunderstorms.

The type plate is located on the bottom of the set.

For users in the U.K., please follow the boxed instructions ‘Important notes...’ on next page.

Helpful hints:

–To avoid unnecessary energy consumption, always adjust the source selector to TAPE/OFF after using the set. Also check that the tape deck keys are released.

0REPEAT – repeats a track/program/the entire CD.

!DBB (Dynamic Bass Boost)

– turns the bass enhancement on/off.

@VOLUME – adjusts volume level

#CD Display – shows CD functions

Using AC power

1Check if the power/mains voltage, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center.