Electrolux Z5500 Series manual How To Assemble, Step a Remove Dust Cup, Step B Attach Handle

Page 5

How To Assemble

CAUTION: Assemble the cleaner completely before plugging into an electrical outlet.

CAUTION: Moving parts, stay clear of brush roll when plugging in.

NOTE: Features may vary by model yet all parts assemble the same.

Step A Remove Dust Cup

Dust

Cup

Latch

Dust Cup

Handle

Step B Attach Handle

NOTE: Screws must be installed to properly secure the handle.

Handle

Tabs

Two Screw Locations

Slots

Screw Screw

Dust Cup

1.Remove dust cup from unit to expose the two screw installation locations. Release the dust cup by rotating the dust cup latch to the left. Pull out and up on the dust cup handle to remove from unit.

2.Position handle as above. Slide the handle down over the top of the unit, inserting handle tabs into slots on unit.

3.Find the two screws in the accessory bag included in the carton. To secure the handle on the unit, install the two screws.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Important Information Guarantee HOW to Assemble Thermal Cut Off Important SafeguardsBefore YOU Start Service Step a Remove Dust Cup How To AssembleStep B Attach Handle Screw ScrewStep E Store Electrical Cord Step D Store AccessoriesStep C Replace Dust Cup How To Use Electrical Cord Hooks. Wrap electrical cord Thermal Cut OffHow To Use Accessories How to Check and Clear Hose Blockages Brush Roll Belt How To Replace Brush Roll BeltBrush Roll To Change Dust Cup Pleated Filter Emptying the Cyclonic Dust Cup To clean the Pleated FilterReinstalling the Cyclonic Dust Cup To Replace Hepa Filter To Replace Micron FilterProblem Cause Solution 08706 Thank you for purchasing An Electrolux cleaner
Top Page Image Contents