Eureka 3040 manual How to Maintain YourVacuum Cleaner, Maintain Brush Roll part number

!	How to Maintain YourVacuum Cleaner
	Make sure vacuum cleaner is turned off and power cord is unplugged.

Maintain Brush Roll – part number 77315

Motor can become hot with normal use.

Do not remove end caps. Remove hair and threads from brush roll periodically.

!	Check EXT-U Belt. Replace if worn, cut or out of shape – part number 61120C
	Avoid touching the motor shaft when checking brush roll or belt.

How to replace brush roll or belt

1)Use handle release to lower handle flat onto floor (Fig. 1).

Remove Brush Roll Cover

1)Remove 2 screws from the front side of brush roll cover (Fig. 2).

2)Lift and remove brush roll cover (Fig. 3).

Replace EXT-U Belt

1)Remove brush roll and belt.

2)Thread new belt around motor shaft and brush roll (Fig. 4).

Replace Brush Roll

1)Insert left end of brush roll first. Make sure square on brush roll cap is in place.

2)Pull right side of brush roll to stretch belt.

3)Secure right end cap into base (Fig. 5).

4)Rotate brush roll 2 turns to center belt.

5)Replace brush roll cover and two screws (Fig. 6).

Fig. 1

Fig. 3

Fig. 5

Fig. 2

Fig. 4

Fig. 6

Change Light Bulb (on some models) – part number 57940-3

!Make sure vacuum is turned off and power cord is unplugged.

1)Pull up release handle latch and remove dust cup compartment.

2)Unscrew the lens cover and remove old bulb (Fig. 7).

3)Push in new bulb, replace lens cover and screw. (Fig. 8).

4)Replace dust cup compartment, snap release handle down to secure.

Fig. 7

Fig. 8

4Eureka Customer Service HELPLINE 1-800-282-2886

www.eureka.com