Air King Vacuum Cleaner owner manual Customer service, Or replaced

Page 7

customer service: 800.465.7300

3.Circuit Breaker inHouse Panel - Check your house breaker panel - If the circuit breaker if off, you may have too many appliances utilizing that circuit. For best results, your power unit should be on a separate circuit. Try to remove some of the extra circuit load by unplugging other devices. If the breaker continues to cut off - call your service technician.

4.Internal Thermal Switch in Unit - If your unit comes equipped with an internal thermal switch and quits running, it may require 10 minutes to cool off before resetting itself.

5.Electrical Wall Outlet Plug - Sometimes the electric wiring from the house breaker panel to the wall outlet plug can become loose or broken. Plug a lamp or another electric appliance into the outlet to assure that you are getting power. If not, call your electrical contractor.

6.Switch in the Wall Inlet Stuck in Off Position- Plug your flexible hose into the other wall inlets

-if your unit functions normally then the problem lies in the switch or remote control circuit to the inoperative inlet valve. The bolts holding the micro-switch in the inlet valve may have loosened allowing it to move out of position. Remove the wall inlet face plate and tighten the bolts or call your service man.

7.Switch in the Wall Inlet Stuck in On Position- Use your finger to roll the steel ball located in the top of the neck of the inlet. Some foreign material may have become lodged in the hole with the ball, preventing it from moving into its proper position. Caution: if this procedure does not turn your unit off, unplug the power cord and notify your service technician.

8.Remote Control Wire - Broken - Usually, if more than one wall inlet is inoperative, the trouble is in the remote control wiring, and the wire is either loose or broken, and should be tightened

or replaced.

9.Remote Control Wire - Shorted- Unplug one of the remote control wires that is attached to the

side of the power unit - if the unit stops, it indicates that the remote control wire is shorted or one of the wall inlet switches is stuck in the on position. If the procedure for number 6 does not shut the unit off and you cannot locate the short, notify your service man. If the unit does not stop running when you unplug the remote control wire - either the short is in the power unit wiring or

the relay is stuck. Refer to number 20. Caution: Checking the wiring in the power unit should only be attempted by a qualified service technician.

10.Flexible Hose - Plugged- If proper airflow is not obtained through the hose, remove the hose from the vacuum inlet, then start the power unit by activating the wall inlet switch. If the airflow, at the inlet, is good, then this will normally indicate a blockage in the hose or wand. If blockage is in the wand, it can be disassembled and cleaned. If blockage is in the hose, the hose should first be laid out straight, then with the hose plugged into the inlet valve and the power unit running, pick up the hose, starting at the end furthest from the valve and gently stretch about two feet of it at a time as you proceed along the length of the hose toward the inlet valve. It this does not clear the stoppage, then remove the hose cuffs by unscrewing them, and switch them to the other ends of the hose (these cuffs have left hand screw threads so rotate them in a clockwise direction to unscrew from the hose). After this has been done replace the hose in the inlet valve and with the power unit operating, repeat the process of stretching the hose. If this fails to unclog the hose, run (handle first) a screwdriver with at least a 3/4” diameter handle through the hose.

11.Tubing in Wall - Clogged - Check the airflow at the power unit. If the airflow is good here but not at locations further from the power unit, your tubing is either clogged or has broken open. If you cannot repair this, contact your service man. If you turn the power unit on and leave the inlet valve furthest from the power unit open and then check the exhaust from the power unit, you can determine whether you have a break in the tubing or whether the tubing is clogged. If very little air is coming out of the exhaust of the power unit, then it is probably an obstruction in the tubing and not a break.

12.Dirt Canister - Over Filled - Whenever low airflow is experienced the first thing to check is the dirt canister for over filling or clogged filter bag (some models). Refer to Number 13. Read the Operations section of this manual for information on how to clean your dirt canister.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Table of contents Electric shock could occur if used on wet surfaces Important Safety InstructionsGrounding Instructions for Cord Connected Appliance Central vacuum electric power brush for which it is intendedGrounding Instructions for Permanently Connected Appliance Operating Your Central VacuumFor Electric hose or vacuum hose used with extension cord HOW Often should I Check or Empty MY Dirt CANISTER? Maintenance Inverted BAG SystemsProbable Cause Troubleshooting GuideOr replaced Customer serviceUnit Label Customer Service AIR King America Limited WarrantyPage VS80 Build-Up Configuration Contact

Vacuum Cleaner specifications

The Air King Vacuum Cleaner stands out in the competitive landscape of home cleaning appliances, offering a blend of power, efficiency, and innovative technology. Designed to tackle a variety of surfaces, the Air King is engineered to provide a thorough clean while ensuring user convenience and satisfaction.

One of its key features is the powerful suction capability. The Air King is equipped with a high-performance motor that generates ample suction, effectively lifting dirt, debris, and pet hair from carpets, hardwood floors, and upholstery. This makes it an excellent choice for households with pets or children, where messes are common.

Another notable aspect is its lightweight and ergonomic design. Weighing significantly less than many traditional vacuum cleaners, the Air King is easy to maneuver, even in tight spaces. Its ergonomic handle reduces strain during extended cleaning sessions, promoting a comfortable user experience.

The Air King Vacuum Cleaner incorporates advanced filtration technology. Equipped with a HEPA filter, it captures 99.97% of particles, including allergens, dust, and pollen, ensuring cleaner air is released back into the environment. This feature is particularly beneficial for allergy sufferers and those seeking a healthier living space.

Versatility is a hallmark of the Air King, as it comes with multiple attachments to cater to various cleaning needs. From crevice tools for edges to upholstery brushes for delicate fabrics, it is designed to provide a comprehensive cleaning solution. The vacuum also features adjustable suction settings, allowing users to switch between modes based on the surface being cleaned.

Furthermore, the Air King boasts a large-capacity dustbin, reducing the frequency of emptying and enhancing cleaning efficiency. The bagless design eliminates the need for replacement bags, making maintenance straightforward and cost-effective.

Its quiet operation sets the Air King apart, allowing users to clean without disturbing others in the household. This makes it ideal for evening cleaning sessions or when there are small children or pets around.

In summary, the Air King Vacuum Cleaner exemplifies modern cleaning technology with its strong suction power, lightweight design, superior filtration system, versatile attachments, and quiet operation. It provides an efficient and user-friendly solution for maintaining a clean and healthy home environment. Whether you're dealing with everyday dirt or more stubborn messes, the Air King promises to deliver exceptional performance tailored to meet your cleaning needs.
Top Page Image Contents