Troubleshooting
Vacuum cleaner won’t run (continued)
Possible causes | Remedies |
3. Damaged power cord | 3. Unplug, check for damage, replace |
| as necessary |
Vacuum cleaner and tools won’t pick up dirt
Possible causes | Remedies | ||
1. | Incorrect height adjustment | 1. | Adjust powerfoot to correct height |
2. | Hose not attached to suction opening | 2. | Firmly push hose wand into hose |
|
|
| wand base |
3. | Twist 'n Snap hose not securely attached | 3. | Make sure Twist 'n Snap hose is snapped |
|
|
| into locked position |
4. | Crack or hole in hose | 4. | Check hose and replace if needed |
5. | Broken or worn drive belt | 5. | Replace drive belt, see pages |
6. | Rotating floor brush bristles worn | 6. | Replace brush |
7. | Rotating floor brush jammed | 7. | Remove brush and clean debris from |
|
|
| brush ends |
8. | Clog in vacuum | 8. | Clear clogs, see page 15 |
9. | Dirt container full | 9. | Empty dirt container |
10. | Dirt container not installed properly | 10. | Position correctly and lock in place |
11. | Filters are dirty | 11. | Check |
12. | TurboBrush is clogged or debris is wrapped | 12. | See page 14 for Maintaining TurboBrush |
| around the brush roll |
|
|
Vacuum cleaner is difficult to push
Possible causes | Remedies |
1. Incorrect height setting | 1. Adjust powerfoot to correct height setting |
Visible dirt escaping from cleaner
Possible causes | Remedies | ||
1. | Dirt container full | 1. | Empty dirt container |
2. | Filters missing or installed incorrectly | 2. | Check |
|
|
| correct installation |
3. | Dirt container installed incorrectly | 3. | Pull out and |
Other maintenance or service not included in the manual should be performed by an
authorized service representative.
Thank you for selecting a BISSELL product.
Please do not return this product to the store.
For any questions or concerns, BISSELL is happy to be of service.
Contact us directly at
w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1 | 17 |