Bissell 3990 warranty Operation, Power switch, Handle positions

Assembly

Attach vacuum hose and tools (continued)

4.Slide the extension wand and crevice tool together into the storage clip.

5.Slide the dusting brush/upholstery tool into the storage clip.

6.Attach the TurboBrush by snapping it onto the top cap of the upper tank.

Operation

Power switch

The power switch is located just below the handle on the front of the vacuum. Push the rocker switch “ON” (I) to vacuum, and “OFF” (O) when cleaning is complete.

Handle positions

Press the handle release pedal, located on the lower left side of the vacuum, with your foot to place your vacuum into one of three cleaning positions.

1.Upright – For storage and above floor cleaning with tools.

2.Normal Cleaning – Press handle release pedal once. Position used

for most household floor cleaning tasks.

3.Low Cleaning – With the vacuum in normal cleaning position, press handle release pedal again. Use for reaching under low furniture such as tables, chairs or beds.

6.

CAUTION:

Before using your vacuum, make sure that the dirt container is in the locked position and that all filters (pre-motor and HEPA post-motor) are in place. Do not operate your vacuum without these filters.

NOTICE:

For above floor cleaning, the floor brush will continue to rotate but is raised above floor. To prevent carpet damage, do not lean on the vacuum or let the powerfoot tilt forward.

CAUTION:

To avoid personal injury and to prevent the cleaner from falling when cleaning stairs, always place it at the bottom of the stairs.

Tip:

1.

2.

Before cleaning under low furniture, check area first for objects that might harm the unit or block the vacuum hose.

3.

6 w w w . b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1

ug603-2312_3990_507.indd 6

8/13/07 2:38:06 PM