Replacing the post-motor Hepa media filter

The post-motor HEPA media filter assists in the filtration process to return clean air to the room.

1.Unplug the vacuum from electrical outlet.

2.Remove the filter door (located on the rear of the vacuum) by pulling up on the filter door latch.

3.Remove the post-motor HEPA media filter by grasping the lip of the filter frame and pulling up.

4.Replace the post-motor HEPA media filter with a new filter.

NOTE: The post-motor filter is a white, pleated HEPA media filter. This filter is NOT wash- able and must be replaced when it becomes dirty.

NOTE: The HEPA media filter should not be touched, when handling be sure to only touch the frame.

Post-Motor

HEPA Media

Filter

5.Replace the filter door by inserting the two tabs at the top of the filter door and pushing down on the bottom of the filter door.

12 w w w . b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1