Bissell 66Q4 warranty How to use this guide, Assembly, Slide upper handle onto lower handle

Page 6

How to use this guide

This user’s guide has been designed to help you get the utmost satisfaction from your BISSELL ProHeat 2X. You’ll find assembly and operating instructions, safety precautions, as well as maintenance and troubleshooting instructions. Please read this guide thoroughly before assembling your deep cleaner.

Pay particular attention to the product diagram, assembly instructions, and part names. Locate and organize all parts before assembly. Familiarize yourself with the parts and where they go. Following this user’s guide will greatly enhance your ability to get the most performance from your BISSELL ProHeat 2X for many years.

Assembly

Your ProHeat 2X comes in three, easy to assemble components:

Upper Handle

Lower Handle Tool Caddy

The only thing you will need to assemble your

cleaner is a Phillips head

screwdriver.

1.Slide upper handle onto lower handle.

Warning:

Do not plug in your cleaner until you have completely assembled it per the following instructions and are familiar with all instructions and operating procedures.

1.2.

3.4.

2. Screw 3 screws into the marked holes.

3.Place upper hose rack onto back of upper handle, and secure with tapered screw.

4.Place lower hose rack onto back of upper handle by pushing in and sliding down until it snaps into place.

5.Snap tools into the tool caddy as shown in figure 5.

6.Wrap power cord and flex hose as shown in figure 5.

5. Tough

Crevice Tool

Stain Brush

TurboBrush

Holder

Spraying

Crevice Tool

7.Keep flex hose snugly in place by using the hose secure latch.

ProHeat 2X assembly is now complete.

6.

Hose Secure

Latch

6 w w w . b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1

Page 5 Page 7
Image 6
Page 5 Page 7
Contents
ProHeat Thanks for buying a Bissell ProHeat 2X Healthy Home Save These Instructions Accessories Product viewBissell Formulas BissellProHeat 2X assembly is now complete How to use this guideAssembly Slide upper handle onto lower handleDual DirtLifter PowerBrushes Special featuresBuilt-in-Heater feature Custom CleanFlow Gauge CleanShotDry Aire In-1 water tankOperation Easy to remove and clean nozzleBefore you clean ReadyTools dialCarpet cleaning Option B CleanShotPretreating optional Continuous heated cleaning Heater SwitchBeing pulled up 7b. Remove the top of the tank by lifting up on the handle Cleaning with attachments Set Custom Clean for the desired settingCleaning fluid section Return ReadyTools dial to floor settingCoil flex hose around the tool caddy Stain removal Hard floor cleaning Check ReadyTools dial. It should be set on floor cleaningFill the 2-in-1 water tank with hot tap water and set aside Machine care Maintenance and careMachine storage Allow adequate time for floors to dryHead screwdriver and rinsed clean. Replace after cleaning After carpet is dry, vacuum again to remove hair and fuzzTroubleshooting Built-in heater ready light does not illuminateReduce Spray or No Spray Reduce Spray or No Spray DirtLifter PowerBrushes do not turnCleaner not picking up solution RemediesM. 10 p.m. EST Authorized service representativePO Box Grand Rapids MI Attn Consumer Services M. 8 p.m. ESTItem Part No Replacement parts Bissell ProHeatReplacement Parts Not all parts are included with every modelEarn Rewards Points Warranty Bissell ProHeat 2X Healthy Home Limited One Year WarrantyIf your Bissell product should require service
Top Page Image Contents