Troubleshooting
Vacuum cleaner won’t run
WARNING:
To reduce the risk of injury from moving parts and/ or electrical shock, turn Power Switch OFF and disconnect polarized plug from electrical outlet before performing troubleshooting checks.
Possible Causes
1Power cord not plugged in
2Blown fuse/tripped breaker
Vacuum cleaner won’t pick up dirt
Possible Causes
1Incorrect Height Adjustment
2Hose not attached to suction opening
3Twist ‘n Snap Hose not securely attached
4Crack or hole in Hose
5Broken or worn Drive Belt
6Rotating Floor Brush bristles worn
7Rotating Floor Brush jammed
8Clog in vacuum
9Dirt Container full
10Dirt Container not installed properly
11Filters are dirty
12Louvers missing or installed incorrectly
13TurboBrush is clogged or debris is wrapped around the Brush Roll
Remedies
1Check electrical plug
2Check/Replace fuse or reset breaker
Remedies
1Adjust Powerfoot to correct height setting
2Grasp Quick Reach Handle and firmly push Hose Wand onto the suction opening
3Make sure Twist ‘n Snap Hose is snapped into locked position
4Check Hose and replace if needed
5Replace Drive Belt, see pg. 10
6Replace brush
7Remove brush and clean debris from brush ends
8Clear clog, see pg. 11
9Empty Dirt Container
10Position correctly and lock in place
11Check and clean Inner and Outer Circular Filters and
12Check for a clog in the tube in the center of the Dirt Container, clear and properly install Louvers
13Maintaining TurboBrush, see page 9
Tools won't pick up dirt
| Possible Cause | Remedies | |
| 1 Crack or hole in Hose | 1 | Check Hose and replace if needed |
12 | 2 Clog in vacuum | 2 | Clear clog, see pg. 11 |
1/11/06 4:03:41 PM |